Hi,
Am Fr., 3. Sept. 2021 um 22:54 Uhr schrieb Patrick Wildt patrick@blueri.se:
Am Fri, Sep 03, 2021 at 08:25:39PM +0200 schrieb Heiko Thiery:
Hi Patrick,
Am Fr., 3. Sept. 2021 um 16:30 Uhr schrieb Patrick Wildt patrick@blueri.se:
Am Fri, Sep 03, 2021 at 11:01:06AM +0200 schrieb Heiko Thiery:
Hi Patrick,
Am Do., 2. Sept. 2021 um 23:44 Uhr schrieb Patrick Wildt patrick@blueri.se:
The MNT Reform 2 is a modular DIY laptop. In its initial version it is based on the BoundaryDevices i.MX8MQ SoM. Some parts have been lifted from BoundaryDevices official U-Boot downstream project.
Signed-off-by: Patrick Wildt patrick@blueri.se
I just sent a patch to add board support for the Kontron pitx-imx8m that is also based on the imx8mq SOC. I already switched the flash.bin generation to binman. Maybe you can use this patchset as a template and also switch to binman for that board.
-- Heiko
Hi Heiko,
I think that's a good idea. But I seem to be having issues:
U-Boot SPL 2021.10-rc3-00023-g2c634e01b6-dirty (Sep 03 2021 - 18:22:04 +0200) Normal Boot Could not get FIT buffer of 686592 bytes check CONFIG_SYS_SPL_MALLOC_SIZE
I'm not sure, but could you check that no old fragments are left in the output folder before building the flash.bin with binman. I can remember that I had also some strange issues while switching to binman.
No change. Is your u-boot.itb that much smaller?
-rw-r--r-- 1 patrick patrick 670K Sep 4 00:50 imx8mq_reform2/u-boot.itb
My u-boot.itbs: -rw-r--r-- 1 hthiery hthiery 686440 Sep 4 07:41 u-boot.itb