On Sel, 2017-06-06 at 10:03 +0200, Marek Vasut wrote:
On 06/06/2017 08:35 AM, tien.fong.chee@intel.com wrote:
From: Tien Fong Chee tien.fong.chee@intel.com
Enable FPGA driver build for SPL because FPGA driver is needed for SPL to configure and getting DDR up before loading U-boot into DDR and booting from there.
FPGA driver build on SPL must be enabled 1st before applying next patch to avoid build failed, because fpga_manager which would be moved to drivers/fpga by next patch are required in SPL.
Signed-off-by: Tien Fong Chee tien.fong.chee@intel.com
You should probably swap this and 4/5 ?
I have no strong opinion about this swapping. Don't you think that it's much more sensible having enabling FPGA support on SPL(configuration 1st), then only enable the build?
drivers/Makefile | 1 + 1 file changed, 1 insertion(+)
diff --git a/drivers/Makefile b/drivers/Makefile index 64c39d3..4478212 100644 --- a/drivers/Makefile +++ b/drivers/Makefile @@ -48,6 +48,7 @@ obj-$(CONFIG_OMAP_USB_PHY) += usb/phy/ obj-$(CONFIG_SPL_SATA_SUPPORT) += block/ obj-$(CONFIG_SPL_USB_HOST_SUPPORT) += block/ obj-$(CONFIG_SPL_MMC_SUPPORT) += block/ +obj-$(CONFIG_SPL_FPGA_SUPPORT) += fpga/ endif ifdef CONFIG_TPL_BUILD