Add wkup_gpio pinmux setting which will be used for performing the DT fixup for hbmc node according to mux selection state, on J721E EVM, hypermux sel is tied to ·WKUP_GPIO0_8.
Signed-off-by: Vaishnav Achath vaishnav.a@ti.com --- arch/arm/dts/k3-j721e-common-proc-board.dts | 11 +++++++++++ 1 file changed, 11 insertions(+)
diff --git a/arch/arm/dts/k3-j721e-common-proc-board.dts b/arch/arm/dts/k3-j721e-common-proc-board.dts index f3b6302a43..1b600547c0 100644 --- a/arch/arm/dts/k3-j721e-common-proc-board.dts +++ b/arch/arm/dts/k3-j721e-common-proc-board.dts @@ -213,6 +213,12 @@ >; };
+ wkup_gpio_pins_default: wkup-gpio-pins-default { + pinctrl-single,pins = < + J721E_WKUP_IOPAD(0xd0, PIN_INPUT, 7) /* (C14) WKUP_GPIO0_8 */ + >; + }; + mcu_fss0_ospi1_pins_default: mcu-fss0-ospi1-pins-default { pinctrl-single,pins = < J721E_WKUP_IOPAD(0x34, PIN_OUTPUT, 0) /* (F22) MCU_OSPI1_CLK */ @@ -381,6 +387,11 @@ phy-names = "cdns3,usb3-phy"; };
+&wkup_gpio0 { + pinctrl-names = "default"; + pinctrl-0 = <&wkup_gpio_pins_default>; +}; + &usbss1 { pinctrl-names = "default"; pinctrl-0 = <&main_usbss1_pins_default>;