Setup pin mux for GPIO pins connected on rev3 or later boards. Also change NUB2 IRQ pin. This should not affect older boards because they don't have any nubs (analog controllers) attached to them. --- board/omap3/pandora/pandora.h | 11 ++++++++++- 1 files changed, 10 insertions(+), 1 deletions(-)
diff --git a/board/omap3/pandora/pandora.h b/board/omap3/pandora/pandora.h index 3d04b2a..1bd3d30 100644 --- a/board/omap3/pandora/pandora.h +++ b/board/omap3/pandora/pandora.h @@ -242,13 +242,15 @@ const omap3_sysinfo sysinfo = { /* - WIFI_IRQ*/\ MUX_VAL(CP(MCBSP1_FSX), (IEN | PTD | DIS | M4)) /*GPIO_161*/\ /* - nIRQ_NUB1*/\ - MUX_VAL(CP(CAM_WEN), (IEN | PTU | DIS | M4)) /*GPIO_167*/\ + MUX_VAL(CP(MCBSP1_CLKX), (IEN | PTU | DIS | M4)) /*GPIO_162*/\ /* - nIRQ_NUB2*/\ /*Various other stuff*/\ MUX_VAL(CP(UART3_CTS_RCTX), (IEN | PTD | DIS | M4)) /*GPIO_163*/\ /* - nOC_USB5*/\ MUX_VAL(CP(ETK_D8_ES2), (IEN | PTD | DIS | M4)) /*GPIO_22*/\ /* - MSECURE*/\ + MUX_VAL(CP(CSI2_DY1), (IEN | PTD | DIS | M4)) /*GPIO_115*/\ + /* - POP_OVERHEAT*/\ /*External Resets and Enables*/\ MUX_VAL(CP(ETK_D0_ES2), (IDIS | PTD | DIS | M4)) /*GPIO_14*/\ /* - nHDPHN_SHUTDOWN*/\ @@ -262,6 +264,13 @@ const omap3_sysinfo sysinfo = { /* - RESET_NUBS*/\ MUX_VAL(CP(UART3_RTS_SD), (IDIS | PTU | EN | M4)) /*GPIO_164*/\ /* - EN_USB_5V*/\ + /*Spare GPIOs*/\ + MUX_VAL(CP(GPMC_NCS7), (IEN | PTD | EN | M4)) /*GPIO_58*/\ + MUX_VAL(CP(GPMC_WAIT2), (IEN | PTD | EN | M4)) /*GPIO_64*/\ + MUX_VAL(CP(GPMC_WAIT3), (IEN | PTD | EN | M4)) /*GPIO_65*/\ + MUX_VAL(CP(CAM_VS), (IEN | PTU | EN | M4)) /*GPIO_95*/\ + MUX_VAL(CP(CAM_WEN), (IEN | PTD | EN | M4)) /*GPIO_167*/\ + MUX_VAL(CP(HDQ_SIO), (IEN | PTD | EN | M4)) /*GPIO_170*/\ /*HS USB OTG Port (connects to HSUSB0)*/\ MUX_VAL(CP(HSUSB0_CLK), (IEN | PTD | DIS | M0)) /*HSUSB0_CLK*/\ MUX_VAL(CP(HSUSB0_STP), (IDIS | PTU | EN | M0)) /*HSUSB0_STP*/\