Use CONFIG_RAMBOOT_PBL instead of CONFIG_PBL_BOOT_INDIRECT according to
Kumar's comment.
CONFIG_RAMBOOT_PBL needs to be documented in the README!
[Xie Shaohui] OK, I'll submit a patch of README.
/* TLB 1 */ /* *I*** - Covers boot page */ +#if defined(CONFIG_SYS_RAMBOOT) && defined(CONFIG_SYS_INIT_L3_ADDR)
- /* *I*G - L3SRAM. When L3 is used as 1M SRAM, the address of the
* SRAM is at 0xfff00000, it covered the 0xfffff000.* */Incorrect multiline comment style. Please fix globally.
[Xie Shaohui] OK.
--- a/include/configs/corenet_ds.h +++ b/include/configs/corenet_ds.h @@ -28,6 +28,10 @@
#include "../board/freescale/common/ics307_clk.h"
+#ifdef CONFIG_RAMBOOT_PBL +#define CONFIG_RAMBOOT_TEXT_BASE 0xfff80000 +#endif
Why is this needed? You already set SYS_TEXT_BASE to that value.
[Xie Shaohui] You are right; this is not needed after boards.cfg is used.
@@ -62,11 +66,17 @@ #ifdef CONFIG_SYS_NO_FLASH #define CONFIG_ENV_IS_NOWHERE #else -#define CONFIG_ENV_IS_IN_FLASH
Why remove the CONFIG_ENV_IS_IN_FLASH here, but leave the CONFIG_ENV_IS_NOWHERE above?
#define CONFIG_FLASH_CFI_DRIVER #define CONFIG_SYS_FLASH_CFI #endif
+#if defined(CONFIG_RAMBOOT_PBL)
- #define CONFIG_ENV_IS_NOWHERE 1 /* Store ENV in memory only */
+#else
- #define CONFIG_ENV_IS_IN_FLASH
- #define CONFIG_ENV_ADDR (CONFIG_SYS_MONITOR_BASE -
CONFIG_ENV_SECT_SIZE)
+#endif
See previous comment. This should be cleaned up. For example, move this block up, and set CONFIG_SYS_NO_FLASH instead.
[Xie Shaohui] OK, I'll clean up these codes.
+#define CONFIG_SYS_L3_SIZE (1024 << 10) +#define CONFIG_SYS_INIT_L3_END (CONFIG_SYS_INIT_L3_ADDR + +CONFIG_SYS_L3_SIZE)
+/*
Drop one of the blank lines, please.
[Xie Shaohui] OK. Thanks.
Best Regards, Shaohui Xie