在 2021/6/21 8:33, Andre Przywara 写道:
On Wed, 16 Jun 2021 10:33:23 +0800 qianfanguijin@163.com (qianfanguijin@163.com) wrote:
Hi,
first many thanks for sending this! Indeed OTG support was broken/missing on the R40, also in Linux. So it seems you have the found the problem: the missing PHY multiplex. Many thanks for that! This indeed enables OTG functionality for me (although with some changes). That means that actually a similar patch needs to go through Linux. Do you plan on enabling support in Linux as well?
sure.
From: qianfan Zhao qianfanguijin@163.com
The address of sun8i_r40's phyctrl is 0x01c13404,
But this isn't quite right, is it? See below.
Yes, the right address of R40 is 0x01c13410. I had checked the bsp code of allwinner: #if defined (CONFIG_ARCH_SUN50I) || defined (CONFIG_ARCH_SUN8IW10) || defined (CONFIG_ARCH_SUN8IW11)#define USBPHYC_REG_o_PHYCTL 0x0410#else#define USBPHYC_REG_o_PHYCTL 0x0404#endif
But I had no idea why the addres 0x01c13404 can work fine, maybe I load u-boot by using sunxi-tools, that the usb otg is already init by IBR.
enable_pmu and dual_route.
Ah, of course! The R40 is closer to the A33/A23 here, with not having separate EHCI0/OHCI0 controllers, instead relying on the MUSB host IP. So indeed we don't have the PHY multiplex for PHY0. I think this is the root cause of the non-working OTG support so far!
Signed-off-by: qianfan Zhao qianfanguijin@163.com
drivers/phy/allwinner/phy-sun4i-usb.c | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/drivers/phy/allwinner/phy-sun4i-usb.c b/drivers/phy/allwinner/phy-sun4i-usb.c index 5723c98032..608ba46242 100644 --- a/drivers/phy/allwinner/phy-sun4i-usb.c +++ b/drivers/phy/allwinner/phy-sun4i-usb.c @@ -587,10 +587,10 @@ static const struct sun4i_usb_phy_cfg sun8i_r40_cfg = { .num_phys = 3, .type = sun8i_r40_phy, .disc_thresh = 3,
- .phyctl_offset = REG_PHYCTL_A33,
- .phyctl_offset = REG_PHYCTL_A10,
So this doesn't work for me, no device appearing on the host. Also writing anything to this register (+0x04) reads back as 0, so it's not implemented, as in the H3. The register at +0x10 however works, and if I keep the A33 line, OTG indeed works for me. Same in Linux, btw.
.dedicated_clocks = true,
- .enable_pmu_unk1 = true,
- .phy0_dual_route = true,
- .enable_pmu_unk1 = false,
- .phy0_dual_route = false,
If they are false, you don't need to list them, the default of 0 will take care of this.
Thanks for yours guide, I will make a change later.
Cheers, Andre
};
static const struct sun4i_usb_phy_cfg sun8i_v3s_cfg = {