To enable memory map in dra7xx, specific chip select must be written to control module register. But this hard coded to chip select 1, fixing it by writing the specific chip select value to control module register.
Signed-off-by: Mugunthan V N mugunthanvnm@ti.com Reviewed-by: Simon Glass sjg@chromium.org Reviewed-by: Tom Rini trini@konsulko.com Reviewed-by: Jagan Teki jteki@openedev.com --- drivers/spi/ti_qspi.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/spi/ti_qspi.c b/drivers/spi/ti_qspi.c index ecd9d78..36bf206 100644 --- a/drivers/spi/ti_qspi.c +++ b/drivers/spi/ti_qspi.c @@ -41,7 +41,7 @@ #define QSPI_WC_BUSY (QSPI_WC | QSPI_BUSY) #define QSPI_XFER_DONE QSPI_WC #define MM_SWITCH 0x01 -#define MEM_CS 0x100 +#define MEM_CS(cs) ((cs + 1) << 8) #define MEM_CS_UNSELECT 0xfffff0ff #define MMAP_START_ADDR_DRA 0x5c000000 #define MMAP_START_ADDR_AM43x 0x30000000 @@ -265,7 +265,7 @@ int spi_xfer(struct spi_slave *slave, unsigned int bitlen, const void *dout, writel(MM_SWITCH, &qslave->base->memswitch); #if defined(CONFIG_DRA7XX) || defined(CONFIG_AM57XX) val = readl(CORE_CTRL_IO); - val |= MEM_CS; + val |= MEM_CS(slave->cs); writel(val, CORE_CTRL_IO); #endif return 0;