From: Bhupesh Sharma bhupesh.linux@gmail.com
Add missing wmb() and mb() barriers in the u-boot UFS core framework driver to allow registers updates to happen before follow-up read operations.
This makes the barrier placement similar to the Linux UFS driver, synced from the Linux v6.9 release.
Starting from the v6.10 release, the barriers were replaced with a register read-back in [1], this will ported to u-boot in a second time.
[1] https://lore.kernel.org/all/20240329-ufs-reset-ensure-effect-before-delay-v5...
Signed-off-by: Bhupesh Sharma bhupesh.sharma@linaro.org Tested-by: Venkatesh Yadav Abbarapu venkatesh.abbarapu@amd.com --- drivers/ufs/ufs.c | 11 +++++++++++ 1 file changed, 11 insertions(+)
diff --git a/drivers/ufs/ufs.c b/drivers/ufs/ufs.c index 565a6af1404..5d4e5424358 100644 --- a/drivers/ufs/ufs.c +++ b/drivers/ufs/ufs.c @@ -432,6 +432,12 @@ static int ufshcd_make_hba_operational(struct ufs_hba *hba) ufshcd_writel(hba, upper_32_bits((dma_addr_t)hba->utmrdl), REG_UTP_TASK_REQ_LIST_BASE_H);
+ /* + * Make sure base address and interrupt setup are updated before + * enabling the run/stop registers below. + */ + wmb(); + /* * UCRDY, UTMRLDY and UTRLRDY bits must be 1 */ @@ -861,6 +867,9 @@ static int ufshcd_send_command(struct ufs_hba *hba, unsigned int task_tag)
ufshcd_writel(hba, 1 << task_tag, REG_UTP_TRANSFER_REQ_DOOR_BELL);
+ /* Make sure doorbell reg is updated before reading interrupt status */ + wmb(); + start = get_timer(0); do { intr_status = ufshcd_readl(hba, REG_INTERRUPT_STATUS); @@ -1994,6 +2003,8 @@ int ufshcd_probe(struct udevice *ufs_dev, struct ufs_hba_ops *hba_ops) REG_INTERRUPT_STATUS); ufshcd_writel(hba, 0, REG_INTERRUPT_ENABLE);
+ mb(); + err = ufshcd_hba_enable(hba); if (err) { dev_err(hba->dev, "Host controller enable failed\n");