Hello Gong Qianyu,
added Stefano Babic to cc as he is the imx maintainer.
Am 18.12.2015 um 10:38 schrieb Gong Qianyu:
This could avoid executing the code that only applies to i.MX platforms.
The bus_i2c_init() is called before relocation and will assgin value to a static variable. If U-Boot is then still running in a flash device, it's theoretically not allowed to write data to flash without an erasing operation. For i.MX platforms, the U-Boot is always running in DDR.
Actually it causes asynchronous error when the ARM64 system error report is enabled and the flash write protect is set.
Signed-off-by: Gong Qianyu Qianyu.Gong@freescale.com
V3:
- Sorry..Remove an unrelated line in other file.
drivers/i2c/mxc_i2c.c | 12 ++++++++++-- 1 file changed, 10 insertions(+), 2 deletions(-)
Ok, from my side, but it would be better to switch your board(s) to support DM and get rid of this old stuff from this driver.
Reviewed-by: Heiko Schocher hs@denx.de
bye, Heiko
diff --git a/drivers/i2c/mxc_i2c.c b/drivers/i2c/mxc_i2c.c index fa4c82f..b2d15c9 100644 --- a/drivers/i2c/mxc_i2c.c +++ b/drivers/i2c/mxc_i2c.c @@ -581,8 +581,16 @@ void bus_i2c_init(int index, int speed, int unused, return; }
- mxc_i2c_buses[index].idle_bus_fn = idle_bus_fn;
- mxc_i2c_buses[index].idle_bus_data = idle_bus_data;
/*
* Warning: Be careful to allow the assignment to a static* variable here. This function could be called while U-Boot is* still running in flash memory. So such assignment is equal* to write data to flash without erasing.*/if (idle_bus_fn)
mxc_i2c_buses[index].idle_bus_fn = idle_bus_fn;if (idle_bus_data)
mxc_i2c_buses[index].idle_bus_data = idle_bus_data;ret = enable_i2c_clk(1, index); if (ret < 0) {