Hi All, I am working on USB part for vybrid vf-610 processor, We have two ports in the board
when I type usb start in uboot command prompt, It returns as ENODEV for USB0 and when analyzed, It is returning from the below code in ehci-hcd_init function(in ehci-vf.c)
if (init == USB_INIT_HOST && index == 0) return -ENODEV;
If these two lines are commented, the usb start is working and device is found on USB0. Why is this check kept in the code?
Regards, Santhosh
::DISCLAIMER:: ----------------------------------------------------------------------------------------------------------------------------------------------------
The contents of this e-mail and any attachment(s) are confidential and intended for the named recipient(s) only. E-mail transmission is not guaranteed to be secure or error-free as information could be intercepted, corrupted, lost, destroyed, arrive late or incomplete, or may contain viruses in transmission. The e mail and its contents (with or without referred errors) shall therefore not attach any liability on the originator or HCL or its affiliates. Views or opinions, if any, presented in this email are solely those of the author and may not necessarily reflect the views or opinions of HCL or its affiliates. Any form of reproduction, dissemination, copying, disclosure, modification, distribution and / or publication of this message without the prior written consent of authorized representative of HCL is strictly prohibited. If you have received this email in error please delete it and notify the sender immediately. Before opening any email and/or attachments, please check them for viruses and other defects.
----------------------------------------------------------------------------------------------------------------------------------------------------