Previously we had been adjusting CONFIG_SYS_MALLOC_LEN based on if CONFIG_DFU_MMC has been set or not. However, for quite some time this has not been the case as we often include <configs/ti_armv7_common.h> prior to setting CONFIG_DFU_MMC so we would always use 16MiB and then not have enough room for to DFU files. Given the amount of memory we always have, setting a minimum size of 32MiB for malloc is reasonable. However, in the SPL case not only do we not need that much we start running into overlap problems and then will fail to boot. Since we don't need 16MiB in the SPL case, bring this down to 8MiB.
Signed-off-by: Tom Rini trini@konsulko.com --- include/configs/ti_armv7_common.h | 7 ++----- 1 file changed, 2 insertions(+), 5 deletions(-)
diff --git a/include/configs/ti_armv7_common.h b/include/configs/ti_armv7_common.h index d8a8c4a87558..3ec8a8f44997 100644 --- a/include/configs/ti_armv7_common.h +++ b/include/configs/ti_armv7_common.h @@ -146,10 +146,7 @@ * we are on so we do not need to rely on the command prompt. We set a * console baudrate of 115200 and use the default baud rate table. */ -#ifdef CONFIG_DFU_MMC -#define CONFIG_SYS_MALLOC_LEN ((16 << 20) + CONFIG_SYS_DFU_DATA_BUF_SIZE) -#else -#define CONFIG_SYS_MALLOC_LEN (16 << 20) +#define CONFIG_SYS_MALLOC_LEN SZ_32M #endif #define CONFIG_SYS_CONSOLE_INFO_QUIET #define CONFIG_BAUDRATE 115200 @@ -230,7 +227,7 @@ #ifndef CONFIG_SYS_SPL_MALLOC_START #define CONFIG_SYS_SPL_MALLOC_START (CONFIG_SPL_BSS_START_ADDR + \ CONFIG_SPL_BSS_MAX_SIZE) -#define CONFIG_SYS_SPL_MALLOC_SIZE CONFIG_SYS_MALLOC_LEN +#define CONFIG_SYS_SPL_MALLOC_SIZE SZ_8M #endif #ifndef CONFIG_SPL_MAX_SIZE #define CONFIG_SPL_MAX_SIZE (SRAM_SCRATCH_SPACE_ADDR - \