On Mon, Jun 25, 2012 at 09:40:57PM +0900, Tetsuyuki Kobayashi wrote:
Interrupts and exceptions doesn't work in relocated code. It badly use IRQ_STACK_START_IN in rom area as interrupt stack. It is because the vecotr table is not moved to ram area. This patch moves vector table before jumping relocated code.
Signed-off-by: Tetsuyuki Kobayashi koba@kmckk.co.jp
arch/arm/cpu/armv7/start.S | 12 ++++++++++++ 1 file changed, 12 insertions(+)
diff --git a/arch/arm/cpu/armv7/start.S b/arch/arm/cpu/armv7/start.S index 52f7f6e..5098f7b 100644 --- a/arch/arm/cpu/armv7/start.S +++ b/arch/arm/cpu/armv7/start.S @@ -277,6 +277,18 @@ jump_2_ram: mcr p15, 0, r0, c7, c10, 4 @ DSB mcr p15, 0, r0, c7, c5, 4 @ ISB #endif +/*
- Move vector table
- */
+#if !defined(CONFIG_TEGRA2) +#if !(defined(CONFIG_OMAP44XX) && defined(CONFIG_SPL_BUILD))
- /* Set vector address in CP15 VBAR register */
- ldr r0, =_start
- add r0, r0, r9
- mcr p15, 0, r0, c12, c0, 0 @Set VBAR
+#endif +#endif /* !Tegra2 */
- ldr r0, _board_init_r_ofs adr r1, _start add lr, r0, r1
I think this code should get boot tested on a few platforms to make sure it's OK. As such, I've tried on am335x and omap3 and they're still fine.
Tested-by: Tom Rini trini@ti.com