On 4/6/22 14:40, Adam Ford wrote:
On Wed, Apr 6, 2022 at 7:27 AM Fabio Estevam festevam@gmail.com wrote:
Hi Adam,
On Wed, Apr 6, 2022 at 9:22 AM Adam Ford aford173@gmail.com wrote:
I tried to build the imx8mq last night, but I ran into issues. I never built an imx8mq bootloader before, so I think I'm missing something. I'll try to get to it again this week. Sorry for the delays.
Please check doc/board/nxp/imx8mq_evk.rst for a reference.
Thanks for the heads up on the help file. I was looking in the wrong place for it.
The flash.bin offset is 33K instead of 32K on imx8mm.
Unfortunately, the board hangs:
U-Boot SPL 2022.04-rc5-gfd0c0181d8 (Apr 06 2022 - 07:36:33 -0500) PMIC: PFUZE100 ID=0x10 Normal Boot Trying to boot from MMC2
<hang>
I am not sure if it's related to your changes or something else is broken. I have to switch gears for now, but I'll try the master branch to see if there are any differences in behavior once I have some more time.
Did you use the correct ATF blob ? Did you set correct ATF_LOAD_ADDR during build ? Did you use the correct set of DRAM PHY blobs ?
This hang looks very much like hang due to bad ATF , unrelated to this series.