On Wed, Dec 27, 2017 at 1:55 PM, Florian Fainelli f.fainelli@gmail.com wrote:
On 12/09/2017 03:02 PM, Joe Hershberger wrote:
On Sat, Dec 9, 2017 at 4:59 PM, Florian Fainelli f.fainelli@gmail.com wrote:
Hi all,
This patch series adds support for the Broadcom BCM53xx switches, in particular BCM53125 which is found no the Lamobo R1 board.
The driver is largely based on the DSA/b53 driver Linux driver and only incorporates what is necessary to succesfully bring-up all ports (including the management port) for boot over the network:
=> dhcp dw_adjust_link: Speed: 1000, full duplex BOOTP broadcast 1 DHCP client bound to address 192.168.0.11 (3 ms) Using ethernet@01c50000 device TFTP from server 192.168.0.1; our IP address is 192.168.0.11 Filename 'sun7i-a20-lamobo-r1-kernel.bin'. Load address: 0x42000000 Loading: ################################################################# ################################################################# ################################ 11.6 MiB/s done Bytes transferred = 2371552 (242fe0 hex) =>
Joe there is one warning left which does not look legit to me since we now have a help paragraph describing the config symbol:
WARNING: please write a paragraph that describes the config symbol fully #34: FILE: drivers/net/phy/Kconfig:15: +config B53_SWITCH
and one CHECK left which I intentionally did not fix because it makes the definitions of the bits less clear: CHECK: Prefer using the BIT macro #134: FILE: drivers/net/phy/b53.c:63: +#define PORT_OVERRIDE_SPEED_100M (1 << PORT_OVERRIDE_SPEED_S)
Works for me.o
Should I expect you to queue up these patches in a git tree/branch, or is someone else picking up networking/PHY patches?
Sorry for the delay - I was out for a few weeks and couldn't get things in before I left due to people's bad patches breaking build.
Pull request sent today includes this.
Cheers, -Joe