Hi Naveen,
Hi,
When I applied the patch to my u-boot sources, it gave me an error. So i carried out the changes manually and compiled the u-boot.
In my experience it's preatty hard to have a patch that works "out of the box"! ;-)
Then i used the new u-boot as the bootloader. After downloading the NK.bin source on to the SDRAM using tftp, i gave the following command. # bootm 0x10000000
But it prompted that "Invalid file format".
This is normal.. NK.bin it's not in "u-boot format" (required by bootm) you should use bootwince command:
# bootwince 0x10000000
Even i tried with the NK.bn0 which is a raw binary file in winCE, but i got the same error.
Same as above. NK.nb0 is a plain binary file, ready to be executed (with the only requirement that it should be loaded at the right address). You should just run WinCE from NK.nb0 by executing:
# go 0x10000000 [or whatever your address is..]
On the same OSK board if i have to support the lcd display in the u-boot itself what are the things that i have to take care?
Sorry.. I cannot help you here! :-)
Best Regards,
Andrea Scian DAVE Srl - Electronics System House
Thanks in advance, Naveen