Hi Joel,
On 22.03.20 19:46, Joel Johnson wrote:
I just wanted to ping on this review (http://patchwork.ozlabs.org/project/uboot/list/?series=155533) to see if it had reached an agreeable state or if there were still lingering issues. I've been using it without issue against RC releases.
If the plan is to not include it in v2020.04 that's completely reasonable, but I would request review and feedback on blocking issues, otherwise does it have general agreement for merging in the next merge window?
I won't pull this into v2020.04 as you might understand. I was hoping to get some reviews and testing from people with access to those boards.
Baruch, could you please check again, if you agree with this approach? Or do you have some change request for this build-time vs run-time detection?
Thanks, Stefan
Thanks, Joel
On 2020-01-27 13:01, Joel Johnson wrote:
This patch series adds support for ClearFog Base static configuration, as well as updating and fixing the ClearFog support for MMC and SPI booting.
v2 changes: - updated against, and dependent on, https://patchwork.ozlabs.org/cover/1200324 v3 changes: - rebased against ClearFog runtime TLV EEPROM changes merged into mvebu/master v4 - adjust static SerDes configuration at runtime instead of #ifdef v5 - distinguish build-only config changes (SFP and PCIe/SATA) from runtime detectable config changes - retested SATA mode in PCIe slot with swap rx changes, confirmed working as presently patched. Only tested with ClearFog Base which only provides single channel, but Pro mechanism is parallel.
Joel Johnson (12): arm: mvebu: fix SerDes table alignment arm: mvebu: solidrun: remove hardcoded DTS MAC address arm: mvebu: clearfog: use Pro name by default arm: mvebu: clearfog: initial ClearFog Base variant arm: mvebu: clearfog: Add option for 2.5 Gbps SFP arm: mvebu: clearfog: Add SATA mode flags arm: mvebu: clearfog: Unify DT selection paths arm: mvebu: clearfog: add SPI offsets arm: mvebu: enable working default boot support arm: mvebu: clearfog: move ENV params to Kconfig arm: mvebu: clearfog: don't always use SPL MMC arm: mvebu: clearfog: Use Pro DT by default
.../arm/dts/armada-38x-solidrun-microsom.dtsi | 1 - arch/arm/mach-mvebu/Kconfig | 13 ++++ .../serdes/a38x/high_speed_env_spec.c | 6 +- board/solidrun/clearfog/Kconfig | 62 +++++++++++++++++++ board/solidrun/clearfog/clearfog.c | 53 +++++++++++++--- configs/clearfog_defconfig | 4 -- include/configs/clearfog.h | 1 - 7 files changed, 124 insertions(+), 16 deletions(-) create mode 100644 board/solidrun/clearfog/Kconfig
Viele Grüße, Stefan