Convert imx6sabresd PCI to driver model to fix the following warning: ===================== WARNING ====================== This board does not use CONFIG_DM_PCI Please update the board to use CONFIG_DM_PCI before the v2019.07 release. Failure to update by the deadline may result in board removal. See doc/driver-model/MIGRATION.txt for more info. ==================================================== After the conversion the following commands were used for testing: => pci enum PCI: Failed autoconfig bar 10 PCI: Failed autoconfig bar 10 => pci 1 Scanning PCI devices on bus 1 BusDevFun VendorId DeviceId Device Class Sub-Class Reviewed-by: Fabio Estevam festevam@gmail.com diff --git a/board/freescale/mx6sabresd/mx6sabresd.c b/board/freescale/mx6sabresd/mx6sabresd.c index b346ca4ced..4a208277ac 100644 --- a/board/freescale/mx6sabresd/mx6sabresd.c +++ b/board/freescale/mx6sabresd/mx6sabresd.c @@ -231,16 +231,6 @@ static void setup_spi(void) SETUP_IOMUX_PADS(ecspi1_pads); }
-iomux_v3_cfg_t const pcie_pads[] = {
- IOMUX_PADS(PAD_EIM_D19__GPIO3_IO19 | MUX_PAD_CTRL(NO_PAD_CTRL)), /* POWER */
- IOMUX_PADS(PAD_GPIO_17__GPIO7_IO12 | MUX_PAD_CTRL(NO_PAD_CTRL)), /* RESET */
-};
-static void setup_pcie(void) -{
- SETUP_IOMUX_PADS(pcie_pads);
-}
iomux_v3_cfg_t const di0_pads[] = { IOMUX_PADS(PAD_DI0_DISP_CLK__IPU1_DI0_DISP_CLK), /* DISP0_CLK */ IOMUX_PADS(PAD_DI0_PIN2__IPU1_DI0_PIN02), /* DISP0_HSYNC */ @@ -508,7 +498,6 @@ int overwrite_console(void) int board_eth_init(bd_t *bis) { setup_iomux_enet();
setup_pcie();
return cpu_eth_init(bis);
} diff --git a/configs/mx6sabresd_defconfig b/configs/mx6sabresd_defconfig index 0bd686ec86..e3b8908928 100644 --- a/configs/mx6sabresd_defconfig +++ b/configs/mx6sabresd_defconfig @@ -83,6 +83,7 @@ CONFIG_SPI_FLASH_STMICRO=y CONFIG_PHYLIB=y CONFIG_MII=y CONFIG_PCI=y +CONFIG_DM_PCI=y CONFIG_PINCTRL=y CONFIG_PINCTRL_IMX6=y CONFIG_DM_REGULATOR=y
Applied to u-boot-imx, master, thanks !
Best regards, Stefano Babic