Re: [U-Boot] [PATCH 1/3] omap4: panda: disable uart2 pads during boot

Tero, [snip]

...

...

• {UART2_CTS, (PTU | IEN | M0)},                                  /* uart2_cts */
• {UART2_RTS, (M0)},                                              /* uart2_rts */
• {UART2_RX, (PTU | IEN | M0)},                                   /* uart2_rx */
• {UART2_TX, (M0)},                                               /* uart2_tx */

• {UART2_CTS, (PTU | IEN | M7)},                                  /* uart2_cts */
• {UART2_RTS, (M7)},                                              /* uart2_rts */
• {UART2_RX, (PTU | IEN | M7)},                                   /* uart2_rx */
• {UART2_TX, (M7)},                                               /* uart2_tx */

{HDQ_SIO, (M3)},                                                /* gpio_127 */        {MCSPI1_CLK, (IEN | OFF_EN | OFF_PD | OFF_IN | M0)},            /* mcspi1_clk */        {MCSPI1_SOMI, (IEN | OFF_EN | OFF_PD | OFF_IN | M0)},           /* mcspi1_somi */ --

How about not muxing and keeping the pads at reset modes ( safe mode).  If this works , then better to remove these pads from the table.

This works also, just tried it out to double check.

Thanks. Then better to just remove these entries.

Thanks, Sricharan