Le lundi 14 avril 2008 à 11:52 +0200, Sander Vermin a écrit :
The official toolchain for U-Boot is the DENX ELDK: http://www.denx.de/wiki/DULG/ELDK . I don't really think this is your issue, but when nothing works it may make sense to put yourself in a well known configuration.
Is there some pre compiled arm version?
ftp://ftp.denx.de/pub/eldk/4.1/arm-linux-x86/iso
ARM support in latest ELDK (4.2) seems to lag a bit ...
Olimex has indeed, but that is a old version of uboot, the old ETHER driver and not the new. I inspected the initialization code on the ARM side, that was the same. The rest of te code is completely different, so spotting differences is difficult.
Ah, I understand. However, there must be a difference somewhere. I'm not sure about this board, but on the SAM boards a software reset has to be performed once the PHY address is configured to activate the PHY (look into at91sam9260.c). Maybe your board needs something equivalent ?
Currently I am using the at91sam9260ek config with the options above edited.
This means that you're doing the soft-reset sequence I told you above (in boards/atmel/at91sam9260ek/at91sam9260ek.c). Maybe your board doesn't need this, try commenting out the relevant code in at91sam9260ek_macb_hw_init() (keep only the gpio set_A/B_periph().