Add a README file to help users getting started with the board.
Signed-off-by: Fabio Estevam fabio.estevam@freescale.com --- board/freescale/mx6ul_14x14_evk/README | 32 ++++++++++++++++++++++++++++++++ 1 file changed, 32 insertions(+) create mode 100644 board/freescale/mx6ul_14x14_evk/README
diff --git a/board/freescale/mx6ul_14x14_evk/README b/board/freescale/mx6ul_14x14_evk/README new file mode 100644 index 0000000..a4c2753 --- /dev/null +++ b/board/freescale/mx6ul_14x14_evk/README @@ -0,0 +1,32 @@ +How to use U-boot on Freescale MX6UL 14x14 EVK +----------------------------------------------- + +- Build U-boot for MX6UL 14x14 EVK: + +$ make mrproper +$ make mx6ul_14x14_evk_defconfig +$ make + +This will generate the SPL image called SPL and the u-boot.img. + +- Flash the SPL image into the micro SD card: + +sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync + +- Flash the u-boot.img image into the micro SD card: + +sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync + +- Jumper settings: + +SW601: 0 0 1 0 +Sw602: 1 0 + +where 0 means bottom position and 1 means top position (from the +switch label numbers reference). + +- Connect the USB cable between the EVK and the PC for the console. +(The USB console connector is the one close the push buttons) + +- Insert the micro SD card in the board, power it up and U-boot messages should +come up.