Re: [U-Boot] [PATCH 1/3] mx6memcal: Fix the UART ports for mx6sabresd/auto boards

On 03/01/2018 15:55, Fabio Estevam wrote:

mx6sabresd board uses the following pins for console:

PAD_CSI0_DAT10__UART1_TX_DATA PAD_CSI0_DAT11__UART1_RX_DATA

,so put it in the same config option as wandboard.

mx6sabreauto board uses the following pins for console:

PAD_KEY_COL0__UART4_TX_DATA PAD_KEY_ROW0__UART4_RX_DATA

So do not mention sabreauto board as part of the UART1_SD3_DAT6_7 option.

The config option for sabreauto can be added later when needed.

Signed-off-by: Fabio Estevam fabio.estevam@nxp.com

board/freescale/mx6memcal/Kconfig | 12 ++---------- 1 file changed, 2 insertions(+), 10 deletions(-)

diff --git a/board/freescale/mx6memcal/Kconfig b/board/freescale/mx6memcal/Kconfig index 443804d..9987cba 100644 --- a/board/freescale/mx6memcal/Kconfig +++ b/board/freescale/mx6memcal/Kconfig @@ -45,20 +45,12 @@ choice NXP SABRELite.

config UART1_CSI0_DAT10_11

• bool "UART1 on CSI0_DAT10/11 (Wand)"
  

• bool "UART1 on CSI0_DAT10/11 (Wand, SabreSD)"
  

  depends on SERIAL_CONSOLE_UART1 help Choose this configuration if you're using pads CSI0_DAT10 and DAT11 for a console on UART1 as

•   is done on the i.MX6 Wand board.
  

• config UART1_SD3_DAT6_7

• bool "UART1 on SD3_DAT6/7 (SabreSD, SabreAuto)"
  

• depends on SERIAL_CONSOLE_UART1
  

• help
  

•   Choose this configuration if you're using pads
  

•   SD3_DAT6 and DAT7 for a console on UART1 as is
  

•   done on the NXP SABRESD or SABREAUTO designs.
  

•   is done on the i.MX6 Wand board and i.MX6 SabreSD.
  
  

  config UART1_UART1 bool "UART1 on UART1 (i.MX6SL EVK, WaRP)"

Applied to u-boot-imx, thanks !

Best regards, Stefano Babic