On Tuesday 08 April 2008, Stefan Roese wrote:
Below is the most of my init.S file. You are correct about the faulting location. But I can see in the init.S file that this address location is defined as "AC_R|AC_W|AC_X|SA_G" so I think I should be able to at least read it. When I boot from 256Mb NAND flash, I don't see this problem. Its only when I boot from 1Gb NAND flash.
Did you get this problem fixed on your board? If yes, what was it?
I'm asking because I'm currently adding 2k page size NAND device support to nand_spl and I'm seeing some strange exception on my target after running from SDRAM.
Never mind. I found my problem. One size was set incorrectly. Now I can boot successfully from 2k page size NAND devices. Patch for review will follow soon.
Best regards, Stefan
===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: office@denx.de =====================================================================