Hi Peter,
On 2023-05-17 21:07, Peter Robinson wrote:
On Wed, May 17, 2023 at 7:41 PM Jonas Karlman jonas@kwiboo.se wrote:
Enable the use of SDMA mode to boost eMMC performance on RockPro64. Also add missing flags to indicate the supported MMC modes.
Using mmc read command to read 32 MiB data shows following improvement:
=> time mmc read 10000000 2000 10000
Before: time: 3.178 seconds After: time: 0.402 seconds
This also enables CONFIG_SPL_FIT_SIGNATURE option to help discover any possible future issue with loading TF-A into DRAM/SRAM.
Signed-off-by: Jonas Karlman jonas@kwiboo.se Reviewed-by: Kever Yang kever.yang@rock-chips.com
v2:
- Collect r-b tag
arch/arm/dts/rk3399-rockpro64-u-boot.dtsi | 5 +++++ configs/rockpro64-rk3399_defconfig | 2 ++ 2 files changed, 7 insertions(+)
diff --git a/arch/arm/dts/rk3399-rockpro64-u-boot.dtsi b/arch/arm/dts/rk3399-rockpro64-u-boot.dtsi index 32a83b2855ac..bd864d067018 100644 --- a/arch/arm/dts/rk3399-rockpro64-u-boot.dtsi +++ b/arch/arm/dts/rk3399-rockpro64-u-boot.dtsi @@ -15,6 +15,11 @@ }; };
+&sdhci {
cap-mmc-highspeed;mmc-ddr-1_8v;+};
Has this been submitted for the upstream Linux kernel DT? The u-boot.dtsi isn't meant to be a general dumping ground for things that should be going upstream. Does it work with the Linux kernel as well as those people that boot using firmware provided DT will get this as well.
It has not been submitted for upstream linux device tree yet. I have patches pending for rk3399-rockpro64 and some rk35xx devices in my local tree, hoping to have them submitted any day now.
This should work with linux, however linux should pick the hs200 mode over ddr52 mode.
With hs200 mode Kconfig enabled in u-boot the above test cmd result in ~0.2 seconds.
Regards, Jonas
Peter
&spi1 { spi_flash: flash@0 { bootph-all; diff --git a/configs/rockpro64-rk3399_defconfig b/configs/rockpro64-rk3399_defconfig index 2b89b1baba51..0ca2cecade25 100644 --- a/configs/rockpro64-rk3399_defconfig +++ b/configs/rockpro64-rk3399_defconfig @@ -20,6 +20,7 @@ CONFIG_SPL_SPI=y CONFIG_SYS_LOAD_ADDR=0x800800 CONFIG_PCI=y CONFIG_DEBUG_UART=y +CONFIG_SPL_FIT_SIGNATURE=y CONFIG_BOOTSTAGE=y CONFIG_BOOTSTAGE_REPORT=y CONFIG_USE_PREBOOT=y @@ -63,6 +64,7 @@ CONFIG_ROCKCHIP_EFUSE=y CONFIG_MMC_DW=y CONFIG_MMC_DW_ROCKCHIP=y CONFIG_MMC_SDHCI=y +CONFIG_MMC_SDHCI_SDMA=y CONFIG_MMC_SDHCI_ROCKCHIP=y CONFIG_SF_DEFAULT_BUS=1 CONFIG_SPI_FLASH_GIGADEVICE=y -- 2.40.1