Dear Jean-Christophe,
Jean-Christophe PLAGNIOL-VILLARD wrote:
On 07:56 Sat 16 May , Dirk Behme wrote:
Some OMAP3 boards need control for external power companion chips. Introduce a CONFIG option for this, to avoid Makefile changes for each board.
Signed-off-by: Dirk Behme dirk.behme@googlemail.com
IIRC the Revc Change it's companion chip is this code still compatible?
Yes, the code is still compatible. And yes, the companion chip changed. And yes, this is quite confusing ;) Do you still remember what I wrote in one of the other mails "only TI marketing department might understand their chip naming"?
What I understood is that revision A & B BeagleBoards used "OEM" companion chip you will only get in large quantities and manual is NDA. Revision C now uses the "catalogue" device, you will e.g. able to get from DigiKey and manual is publically available. So different chip names, but compatible.
Recent U-Boot mainline is used on rev B and C boards without any difference :)
Best regards
Dirk