Some very similar #defines for reg addresses are used in a later patch (managed_switch support for km_arm).
Signed-off-by: Valentin Longchamp valentin.longchamp@keymile.com cc: Holger Brunck holger.brunck@keymile.com cc: Prafulla Wadaskar prafulla@marvell.com --- board/keymile/km_arm/km_arm.c | 22 +++++++++++----------- 1 files changed, 11 insertions(+), 11 deletions(-)
diff --git a/board/keymile/km_arm/km_arm.c b/board/keymile/km_arm/km_arm.c index a062333..4a6bff1 100644 --- a/board/keymile/km_arm/km_arm.c +++ b/board/keymile/km_arm/km_arm.c @@ -365,13 +365,13 @@ void dram_init_banksize(void)
#if (defined(CONFIG_KM_PIGGY4_88E6061))
-#define PHY_LED_SEL 0x18 -#define PHY_LED0_LINK (0x5) -#define PHY_LED1_ACT (0x8<<4) -#define PHY_LED2_INT (0xe<<8) -#define PHY_SPEC_CTRL 0x1c +#define PHY_LED_SEL_REG 0x18 +#define PHY_LED0_LINK (0x5) +#define PHY_LED1_ACT (0x8<<4) +#define PHY_LED2_INT (0xe<<8) +#define PHY_SPEC_CTRL_REG 0x1c #define PHY_RGMII_CLK_STABLE (0x1<<10) -#define PHY_CLSA (0x1<<1) +#define PHY_CLSA (0x1<<1)
/* Configure and enable MV88E3018 PHY */ void reset_phy(void) @@ -383,15 +383,15 @@ void reset_phy(void) return;
/* RGMII clk transition on data stable */ - if (miiphy_read(name, CONFIG_PHY_BASE_ADR, PHY_SPEC_CTRL, ®) != 0) + if (!miiphy_read(name, CONFIG_PHY_BASE_ADR, PHY_SPEC_CTRL_REG, ®)) printf("Error reading PHY spec ctrl reg\n"); - if (miiphy_write(name, CONFIG_PHY_BASE_ADR, PHY_SPEC_CTRL, - reg | PHY_RGMII_CLK_STABLE | PHY_CLSA) != 0) + if (!miiphy_write(name, CONFIG_PHY_BASE_ADR, PHY_SPEC_CTRL_REG, + reg | PHY_RGMII_CLK_STABLE | PHY_CLSA)) printf("Error writing PHY spec ctrl reg\n");
/* leds setup */ - if (miiphy_write(name, CONFIG_PHY_BASE_ADR, PHY_LED_SEL, - PHY_LED0_LINK | PHY_LED1_ACT | PHY_LED2_INT) != 0) + if (!miiphy_write(name, CONFIG_PHY_BASE_ADR, PHY_LED_SEL_REG, + PHY_LED0_LINK | PHY_LED1_ACT | PHY_LED2_INT)) printf("Error writing PHY LED reg\n");
/* reset the phy */