On 08/12/2012 10:31, Albert ARIBAUD wrote:
Hi Stefano,
Hi Albert,
On Thu, 11 Oct 2012 09:11:46 +0200, Stefano Babic sbabic@denx.de wrote:
The woodburn board is based on the MX35 SOC. Support for both external (NOR) and internal (SD Card) boot mode are added. It uses the generic SPL framework to implement the internal boot mode.
The following peripherals are supported:
- Ethernet (FEC)
- SD Card
- NAND (512 MB)
- NOR Flash
In the internal boot mode, a simple imximage header is generated to set the address in internal RAM where the SOC must copy the SPL code. The initial setup is then demanded to the SPL itself.
Signed-off-by: Stefano Babic sbabic@denx.de
It seems this board uses the old PMIC framework, so it does not merge properly with u-boot/master which has switched to power in-between. Can you look into this?
I must say I'm not entirely sure how to handle this, but here is my proposal: AFAIU this patch was applied initially in your imx tree, so I suggest that you merge u-boot/master into your tree (with a comment to the effect that you need this to resolve PMIC vs POWER conflicts) or into an ad hoc branch, and resolve the conflicts there, then send a pull request to me for your resolved tree or branch.
There are conflicts with three boards : mx35pdk, woodburn and mx53loco.
It seems that a couple of patches were lost in the transition from pmic to power, too:
commit 787f4f30823a15b1e45c0a0b901cfa5bd415e251 Author: Fabio Estevam fabio.estevam@freescale.com Date: Tue Oct 23 06:36:18 2012 +0000
pmic: Add support for mc34704
Add the register layout for the MC34704 PMIC from Freescale.
Signed-off-by: Fabio Estevam fabio.estevam@freescale.com
commit 4cfc6c4fa7611e79e6434e97db56b6072ad4d05c Author: Fabio Estevam fabio.estevam@freescale.com Date: Tue Oct 23 06:34:50 2012 +0000
pmic_fsl: Introduce FSL_PMIC_I2C_LENGTH
I solved the conflicts in the way you suggested and I pushed a temporary branch "master_merge" on u-boot-imx.
I am unsure, too, if this is the best way to solve these conflicts, but if Tom agrees on our way to proceed, I will post a new pull request.
Best regards, Stefano