Hi all,
I've tried the first time booting a self compiled u-boot from git.marvell.com U-Boot can be downloaded and started with openocd quite well. Boot messages (version is dirty due to a comment in board file):
U-Boot 2009.06-rc2-02207-g14c575a-dirty (Jun 22 2009 - 13:40:45) Marvell-Sheevaplug
SoC: Kirkwood 88F6281_A0 DRAM: 512 MB NAND: 512 MiB *** Warning - bad CRC or NAND, using default environment
In: serial Out: serial Err: serial Net: egiga0 88E1116 Initialized on egiga0 Hit any key to stop autoboot: 0 Marvell>>
Environment is broken only with marvell git u-boot. Preflashed u-boot find environment is ok. Does sheevaplug u-boot from marvell git use other environment settings than preflashed u-boot?
Marvell>> printenv bootcmd=${x_bootcmd_kernel}; setenv bootargs ${x_bootargs} ${x_bootargs_root}; bootm 0x6400000; bootdelay=3 baudrate=115200 x_bootargs=console=ttyS0,115200 mtdparts=orion_nand:512k(uboot),3m@1m(kernel),1m@4m(psm),13m@5m(rootfs) rw x_bootcmd_kernel=nand read 0x100000 0x6400000 0x300000 x_bootargs_root=root=/dev/mtdblock3 rw rootfstype=jffs2 stdin=serial stdout=serial stderr=serial ethaddr=00:50:43:e0:b9:d8 ethact=egiga0 ipaddr=192.168.2.75
(ipaddr is set after bootup with setenv ipaddr 192.168.2.75)
If I now try to ping another machine in the same network: Marvell>> ping 192.168.2.251 Using egiga0 device
This is all what happens - no response from board, CTRL-C doesn't work. Only a hard reset will get the board up again.
Do I have to change something in the default board configuration to succesfullly use networking on the sheevaplug?
u-boot is build with following commands:
make ARCH=arm sheevaplug_config make
I get no errors during build.
My gcc version is: arm-none-linux-gnueabi-gcc (GCC) 4.2.0 20070413 (prerelease)
Any help would be appreciated, Dieter