Hi Stefano/Anatolij,
When I activate framebuffer support for mx53loco board I face the following problem (in about half of my attempts to boot the kernel):
Starting kernel ...
Linux version 2.6.35.3-01129-g691c08a (fabio@fabio-Latitude-E6410) (gcc version 4.4.4 (4.4.4_09.06.2010) ) #5 PREEMPT Mon May 14 14:22:49 BRT 2012 CPU: ARMv7 Processor [412fc085] revision 5 (ARMv7), cr=10c53c7f CPU: VIPT nonaliasing data cache, VIPT nonaliasing instruction cache Machine: Freescale MX53 LOCO Board Memory policy: ECC disabled, Data cache writeback Built 1 zonelists in Zone order, mobility grouping on. Total pages: 250880 Kernel command line: console=ttymxc0,115200 root=/dev/nfs ip=dhcp nfsroot=10.29.240.143:,v3,tcp PID hash table entries: 4096 (order: 2, 16384 bytes) Dentry cache hash table entries: 131072 (order: 7, 524288 bytes) Inode-cache hash table entries: 65536 (order: 6, 262144 bytes) Memory: 480MB 512MB = 992MB total Memory: 998528k/998528k available, 17280k reserved, 0K highmem Virtual kernel memory layout: vector : 0xffff0000 - 0xffff1000 ( 4 kB) fixmap : 0xfff00000 - 0xfffe0000 ( 896 kB) DMA : 0xf9e00000 - 0xffe00000 ( 96 MB) vmalloc : 0xe0800000 - 0xf4000000 ( 312 MB) lowmem : 0x80000000 - 0xe0000000 (1536 MB) pkmap : 0x7fe00000 - 0x80000000 ( 2 MB) modules : 0x7f000000 - 0x7fe00000 ( 14 MB) .init : 0x80008000 - 0x80032000 ( 168 kB) .text : 0x80032000 - 0x807b4000 (7688 kB) .data : 0x807d0000 - 0x808234c0 ( 334 kB) SLUB: Genslabs=11, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 Hierarchical RCU implementation. RCU-based detection of stalled CPUs is disabled. Verbose stalled-CPUs detection is disabled. NR_IRQS:368 MXC GPIO hardware MXC IRQ initialized MXC_Early serial console at MMIO 0x53fbc000 (options '115200') bootconsole [ttymxc0] enabled Console: colour dummy device 80x30 Calibrating delay loop... 799.53 BogoMIPS (lpj=3997696) pid_max: default: 32768 minimum: 301 Mount-cache hash table entries: 512 CPU: Testing write buffer coherency: ok regulator: core version 0.5 NET: Registered protocol family 16 i.MX IRAM pool: 128 KB@0xe0840000 IRAM READY CPU is i.MX53 Revision 2.1
(system hangs here)
When framebuffer is not used I can succesfully reboot the board several times.
I know it is a difficult question, but in case you have any ideas/suggestions I would be glad to listen to.
Regards,
Fabio Estevam