
Subject: [PATCH v2 5/9] spi: Add support for SPL_OF_PLATDATA to mxs_spi.c driver
After this patch the mxs_spi.c DM/DTS driver can be used at early SPL to read payload from SPI-NOR memories.
It was necessary to adjust its name to 'fsl_imx_2{38}_spi' to match requirements for SPL_OF_PLATDATA usage.
Signed-off-by: Lukasz Majewski lukma@denx.de
Changes in v2: None
drivers/spi/mxs_spi.c | 34 ++++++++++++++++++++++++++++++++-- 1 file changed, 32 insertions(+), 2 deletions(-)
diff --git a/drivers/spi/mxs_spi.c b/drivers/spi/mxs_spi.c index d475830f17..58b1c67a19 100644 --- a/drivers/spi/mxs_spi.c +++ b/drivers/spi/mxs_spi.c @@ -57,7 +57,18 @@ static inline struct mxs_spi_slave *to_mxs_slave(struct spi_slave *slave) #else #include <dm.h> #include <errno.h> +#include <dt-structs.h>
+#ifdef CONFIG_MX28 +#define dtd_fsl_imx_spi dtd_fsl_imx28_spi #else /* CONFIG_MX23 */ +#define dtd_fsl_imx_spi dtd_fsl_imx23_spi #endif
struct mxs_spi_platdata { +#if CONFIG_IS_ENABLED(OF_PLATDATA)
- struct dtd_fsl_imx_spi dtplat;
+#endif s32 frequency; /* Default clock frequency, -1 for none */ fdt_addr_t base; /* SPI IP block base address */ int num_cs; /* Number of CSes supported */ @@ -430,11 +441,26 @@ static int mxs_spi_probe(struct udevice *bus) int ret;
debug("%s: probe\n", __func__);
+#if CONFIG_IS_ENABLED(OF_PLATDATA)
struct dtd_fsl_imx_spi *dtplat = &plat->dtplat;
struct phandle_1_arg *p1a = &dtplat->clocks[0];
priv->regs = (struct mxs_ssp_regs *)dtplat->reg[0];
priv->dma_channel = dtplat->dmas[1];
priv->clk_id = p1a->arg[0];
priv->max_freq = dtplat->spi_max_frequency;
plat->num_cs = dtplat->num_cs;
debug("OF_PLATDATA: regs: 0x%x max freq: %d clkid: %d\n",
(unsigned int)priv->regs, priv->max_freq, priv->clk_id); #else
priv->regs = (struct mxs_ssp_regs *)plat->base; priv->max_freq = plat->frequency;
priv->dma_channel = plat->dma_id; priv->clk_id = plat->clk_id;
+#endif
mxs_reset_block(&priv->regs->hw_ssp_ctrl0_reg);
@@ -571,16 +597,20 @@ static int mxs_ofdata_to_platdata(struct udevice *bus)
return 0; } -#endif
static const struct udevice_id mxs_spi_ids[] = { { .compatible = "fsl,imx23-spi" }, { .compatible = "fsl,imx28-spi" }, { } }; +#endif
U_BOOT_DRIVER(mxs_spi) = {
- .name = "mxs_spi",
+#ifdef CONFIG_MX28
- .name = "fsl_imx28_spi",
+#else /* CONFIG_MX23 */
- .name = "fsl_imx23_spi",
+#endif .id = UCLASS_SPI, #if CONFIG_IS_ENABLED(OF_CONTROL) && !CONFIG_IS_ENABLED(OF_PLATDATA) .of_match = mxs_spi_ids,
Reviewed-by: Peng Fan peng.fan@nxp.com
-- 2.11.0