On 23/09/2017 04:45, Fabio Estevam wrote:
From: Fabio Estevam fabio.estevam@nxp.com
There is no need call setup_display() from SPL code, so move it to board_init(), which executes only in U-Boot proper.
Reported-by: Stefano Babic sbabic@denx.de Signed-off-by: Fabio Estevam fabio.estevam@nxp.com
board/wandboard/wandboard.c | 5 ++--- 1 file changed, 2 insertions(+), 3 deletions(-)
diff --git a/board/wandboard/wandboard.c b/board/wandboard/wandboard.c index adfcf48..dde4988 100644 --- a/board/wandboard/wandboard.c +++ b/board/wandboard/wandboard.c @@ -376,9 +376,6 @@ int board_eth_init(bd_t *bis) int board_early_init_f(void) { setup_iomux_uart(); -#if defined(CONFIG_VIDEO_IPUV3)
- setup_display();
-#endif #ifdef CONFIG_SATA /* Only mx6q wandboard has SATA */ if (is_cpu_type(MXC_CPU_MX6Q)) @@ -448,6 +445,8 @@ int board_init(void) setup_i2c(1, CONFIG_SYS_I2C_SPEED, 0x7f, &mx6q_i2c2_pad_info); else setup_i2c(1, CONFIG_SYS_I2C_SPEED, 0x7f, &mx6dl_i2c2_pad_info);
- setup_display();
#endif
return 0;
Reviewed-by: Stefano Babic sbabic@denx.de
Best regards, Stefano Babic