Hi Rik,
On Fri, 30 May 2014 10:50:39 +0000 (UTC) Rik Smith rsmith@optos.com wrote:
Chin Liang See <clsee <at> altera.com> writes:
To add the Denali NAND driver support into U-Boot. It required information such as register base address from configuration header file within include/configs folder.
Signed-off-by: Chin Liang See <clsee <at> altera.com> Cc: Artem Bityutskiy <artem.bityutskiy <at> linux.intel.com> Cc: David Woodhouse <David.Woodhouse <at> intel.com> Cc: Brian Norris <computersforpeace <at> gmail.com> Cc: Scott Wood <scottwood <at> freescale.com>
Changes for v2
- Enable this driver support for SOCFPGA
drivers/mtd/nand/Makefile | 1 + drivers/mtd/nand/denali_nand.c | 1166
++++++++++++++++++++++++++++++++++++++++
drivers/mtd/nand/denali_nand.h | 501 +++++++++++++++++ 3 files changed, 1668 insertions(+) create mode 100644 drivers/mtd/nand/denali_nand.c create mode 100644 drivers/mtd/nand/denali_nand.h
Hi, I was wondering which kernel this patch went into or is going into?
I am having problems with accessing a hynix NAND from an altera cyclone V using kernel 3.11. It is coming up with a kernel driver error on boot of: "Your NAND chip OOB is not large enough to contain 8bit ECC correction codes"
This is not a driver for Linux Kernel, but for U-Boot (boot loader).
Best Regards Masahiro Yamada