On Wed, Jan 05, 2022 at 05:52:23PM -0300, Fabio Estevam wrote:
Hi Tommaso,
On Wed, Jan 5, 2022 at 5:47 PM Tommaso Merciai tomm.merciai@gmail.com wrote:
Hi Fabio, Thanks, I test your patch on basic and extended model. Below some logs seems all work properly. I hope I helped the cause :)
Yes, thanks a lot!
- BASIC log:
U-Boot 2022.01-rc4-00034-g19f31e718f-dirty (Jan 05 2022 - 21:38:32 +0100)
CPU: Freescale i.MX6SX rev1.2 996 MHz (running at 792 MHz) CPU: Extended Commercial temperature grade (-20C to 105C) at 32C Reset cause: POR Model: UDOO Neo Basic
I assume you have only applied 1/2 and not 2/2.
With 2/2 applied the Model line should not be printed.
Thanks
Yes, Fabio. Sorry, I forgot. Below test with 2/2.
U-Boot 2022.01-rc4-00034-g19f31e718f-dirty (Jan 05 2022 - 22:07:22 +0100)
CPU: Freescale i.MX6SX rev1.2 996 MHz (running at 792 MHz) CPU: Extended Commercial temperature grade (-20C to 105C) at 45C Reset cause: POR Board: UDOO Neo BASIC I2C: ready DRAM: 512 MiB PMIC: PFUZE3000 DEV_ID=0x30 REV_ID=0x11 MMC: FSL_SDHC: 1, FSL_SDHC: 2 Loading Environment from MMC... OK In: serial Out: serial Err: serial Net: eth0: ethernet@2188000 Hit any key to stop autoboot: 0
U-Boot 2022.01-rc4-00034-g19f31e718f-dirty (Jan 05 2022 - 22:07:22 +0100)
CPU: Freescale i.MX6SX rev1.2 996 MHz (running at 792 MHz) CPU: Extended Commercial temperature grade (-20C to 105C) at 35C Reset cause: POR Board: UDOO Neo EXTENDED I2C: ready DRAM: 1 GiB PMIC: PFUZE3000 DEV_ID=0x30 REV_ID=0x11 MMC: FSL_SDHC: 1, FSL_SDHC: 2 Loading Environment from MMC... OK In: serial Out: serial Err: serial Net: Error: ethernet@2188000 address not set. No ethernet found.
Hit any key to stop autoboot: 0
Thanks, Tommaso