Hi! I'm trying to boot from u-boot on a Raspberry Pi 3. But for some reason it isn't autobooting on the SD-card.
Is it possible to get more debug output on the screen console? I don't have a serial console at the moment. The output on the screen is:
Net: No ehternet found. starting USB... USB: Core Release 2.80a scanning bus 0 for devices... 4 USB Devices found scanning usb for storage devices... 0 Storage Device(s) found Hit any key to stop autoboot: 0 U-Boot>
Shouldn't it mention mmc somewhere in the boot message?
The first command I type on the prompt is always failing, it's not outputting anything. Just a new prompt on the next line. The next commands i type in are working. Which seems strange. I got boot.scr set up right, except graphic settings which are wrong. It is booting the kernel when I type 'run bootcmd'. But only after I type in another command before it. It seems like it's not detecting the SD-card (mmc0) until I have typed anything into the prompt.
Do I have to set any other env variable for it to autoboot? I would have printed the output of printenv here, but since I don't have a serial console, retyping everything is very time consuming. printenv seems to have the right settings. It's basically a full console screen of variables. It just doesn't seem to load them until I type in another command before it.
boot_targets=mmc0 usb0 pxe dhcp Which seems right to me.
I compiled the latest u-boot from github.
If you need more info please let me know and I'll post it.
Hope that anyone can point me in the right direction here. Would really appreciate it.
I'm seeing the same issues with 2018.03 rc3.
I'm not sure what the issue is and I've not had time to investigate it further yet, but if you type "boot" and hit enter it should boot, sometimes you actually have to type it twice. It will boot but I'm not sure which bits here have causes this regression.
I do not see this at all on my RPi3. Maybe it's firmware version dependent? Do you happen to have an image that always fails for you?
2018.03 rc3 with "2018-02-09" firmware (so fairly recent) fails for me.
Alex
U-Boot 2018.03-rc3-00109-g77bba970e2-dirty (Mar 05 2018 - 11:06:36 +0100)
DRAM: 992 MiB RPI 3 Model B (0xa02082) MMC: mmc@7e202000: 0, sdhci@7e300000: 1 Loading Environment from FAT... *** Warning - bad CRC, using default environment
Failed (-5) In: serial Out: vidconsole Err: vidconsole Net: No ethernet found. starting USB... USB0: Core Release: 2.80a scanning bus 0 for devices... 4 USB Device(s) found scanning usb for storage devices... 0 Storage Device(s) found Hit any key to stop autoboot: 0 switch to partitions #0, OK mmc0 is current device Scanning mmc 0:1... Found EFI removable media binary efi/boot/bootaa64.efi libfdt fdt_check_header(): FDT_ERR_BADMAGIC Scanning disk mmc@7e202000.blk... Card did not respond to voltage select! Scanning disk sdhci@7e300000.blk... Disk sdhci@7e300000.blk not ready Found 4 disks 840192 bytes read in 38 ms (21.1 MiB/s) libfdt fdt_check_header(): FDT_ERR_BADMAGIC ## Starting EFI application at 01000000 ... Welcome to GRUB!