Re: [U-Boot] [PATCH v4 2/6] MX31: Add NAND SPL for i.MX31.

On 20:50 Sat 13 Jun , Magnus Lilja wrote:

This patch adds the NAND SPL framework needed to boot i.MX31 boards from NAND.

It has been tested on a i.MX31 PDK board with large page NAND. Small page NANDs should work as well, but this has not been tested.

Note: The i.MX31 NFC uses a non-standard layout for large page NANDs, whether this is compatible with a particular setup depends on how the NAND device is programmed by the flash programmer (e.g. JTAG debugger).

The patch is based on the work by Maxim Artamonov.

Signed-off-by: Maxim Artamonov scn1874@yandex.ru Signed-off-by: Magnus Lilja lilja.magnus@gmail.com

---

Applied to u-boot-arm

Best Regards, J.