Dear Stefan Roese,
In message 1242035235-26833-1-git-send-email-sr@denx.de you wrote:
Here the commands to load and start this image from the BDI2000:
440EPX>load 0x1000000 /tftpboot/sequoia/u-boot.bin 440EPX>go 0x1000000
I assume you used "reset halt" before?
Please note that this image automatically scans for an already initialized SDRAM TLB (detected by EPN=0). This TLB will not be
And what happens when the TLB is not correctly set? Will we get a useful error message then?
cleared. So your debugger should configure the SDRAM TLB correctly (as done in the standard Sequoia BDI init script).
Well, standard procedure is to boot using "reset run"; I think you should add the "reset halt" step to the documentation above - just to be sure.
Best regards,
Wolfgang Denk