Am 2019-10-22 15:45, schrieb Michal Simek:
On 22. 10. 19 15:09, Michael Walle wrote:
Am 2019-10-14 15:29, schrieb Michal Simek:
From: Siva Durga Prasad Paladugu siva.durga.paladugu@xilinx.com
This patch adds support for fru commands "fru capture" and "fru display". The fru capture parses the FRU table present at an address and stores in a structure for later use. The fru display prints the content of captured structured in a readable format.
As of now, it supports only common header and board area of FRU. Also, it supports only English language code and ASCII8 format.
fru_data variable is placed to data section because fru parser can be called very early before bss is initialized. And also information needs to be shared that's why it is exported via header.
Wouldn't it make more sense to have a level of indirection so other "fru" formats might be supported as well. As far as I can see, only "your" type of FRU data is supported by this command and there is now way to extend it.
Current code is just showing board information which is what it is in FRU spec and it is common for all. There is no any OEM specific field now.
I didn't meant the (I guess it is the IPMI) FRU spec. But there are also other specifications like the PICMG Embedded EEPROM [1]. What I wanted to say is, that if there will be a new "fru" command, it might make sense to have it more generic. Otherwise, we have the fru command which can only display IPMI FRU spec compliant stuff and in the future, maybe a "picmg" command, which can only display PICMG EEPROM content.
Also why do the user have to manually do a "fru capture"? The use case is to display any FRU data, correct? So from a users perspective a "fru display" be sufficient to display the data.
The code was written for using fru board detection code where capture part can be performed without displaying results. Simply because you need to find where you are running to be able to know which device to use for showing results.
What does a "fru capture" do besides maybe printing an error. Briefly looking at the code, I didn't find anything else. (It sets the fru_data stuff which is used in "fru display" of course).
It means internally it needs to be divided. That's going to second point if make sense to have two separate commands or just one. And it should be ok to have only one command till there is a need to do it differently.
There might be more commands, but IMHO it should be sufficient to run "fru display" to print the data. If I read the code correctly, you have to do a "fru capture; fru display" at the moment; btw in the "fru display" error it reads "please run fru parse", I guess that is a typo.
-michael
[1] https://www.picmg.org/wp-content/uploads/PICMG_EeeP_R1_0.pdf