The Rockchip-specific SDHCI wrapper does not process the 'bus-width' property in the SDHCI node. Consequently, the bus is always kept in 4bit mode, even if 8bit wide operation is available, supported and requested in the DTS.
This change adds processing of the 'bus-width' property and sets the host capability flag for an 8bit wide bus, if set to 8. As the logic in sdhci.c does not support clearing the 4bit capability, we assume that 4bit operation is always supported.
Signed-off-by: Philipp Tomsich philipp.tomsich@theobroma-systems.com
---
drivers/mmc/rockchip_sdhci.c | 8 ++++++++ 1 file changed, 8 insertions(+)
diff --git a/drivers/mmc/rockchip_sdhci.c b/drivers/mmc/rockchip_sdhci.c index be6edb2..ab89be4 100644 --- a/drivers/mmc/rockchip_sdhci.c +++ b/drivers/mmc/rockchip_sdhci.c @@ -62,6 +62,13 @@ static int arasan_sdhci_probe(struct udevice *dev)
host->quirks = SDHCI_QUIRK_WAIT_SEND_CMD; host->max_clk = max_frequency; + /* + * The sdhci-driver only supports 4bit and 8bit, as sdhci_setup_cfg + * doesn't allow us to clear MMC_MODE_4BIT. Consequently, we don't + * check for other bus-width values. + */ + if (host->bus_width == 8) + host->host_caps |= MMC_MODE_8BIT;
ret = sdhci_setup_cfg(&plat->cfg, host, 0, EMMC_MIN_FREQ);
@@ -82,6 +89,7 @@ static int arasan_sdhci_ofdata_to_platdata(struct udevice *dev)
host->name = dev->name; host->ioaddr = dev_read_addr_ptr(dev); + host->bus_width = dev_read_u32_default(dev, "bus-width", 4); #endif
return 0;