Dear Stefan Roese,
In message 1242278687-23685-1-git-send-email-sr@denx.de you wrote:
Currently only IDE busses are probed and all possible available devices are listed in the IDE bootup log. Even when devices on the bus are not available. This leads to the following output on the CPCI750:
IDE: Bus 0: OK Bus 1: OK Device 0: Model: HITACHI_DK23FA-20J Firm: 00M7A0A0 Ser#: 42D182 Type: Hard Disk Capacity: 19077.1 MB = 18.6 GB (39070080 x 512) Device 1: Model: Firm: Ser#: Type: # 1F # Capacity: not available Device 2: Model: SanDisk SDCFB-128 Firm: vde 1.10 Ser#: gmo5i311404 Type: Removable Hard Disk Capacity: 122.5 MB = 0.1 GB (250880 x 512) Device 3: Model: Firm: Ser#: Type: # 1F # Capacity: not available
If my understanding is correct, then this is a bug on your hardware.
#endif @@ -727,8 +728,12 @@ skip_bus: if (!ide_bus_ok[IDE_BUS(i)]) continue; ide_led(led, 1); /* LED on */
ide_ident(&ide_dev_desc[i]);
ret = ide_ident(&ide_dev_desc[i]);if (ret < 0) {puts("not available\n");continue;}
IIRC this should not be needed; normally, ide_bus_ok() should catch this.
Best regards,
Wolfgang Denk