Thanks for the information. But I read some where that for the Lab testing purpose that I can give the IP address!!!!! I am able to read the PHY inforamtion by command mii info 0x01<PHY Addr>. Following is the info.... => mii info 0x01 PHY_PHYIDR2 @ 0x1 = 0x5c90 PHY_PHYIDR[1,2] @ 0x1 = 0x20005c90 PHY_BMCR value is 0x2100 PHY 0x01: OUI = 0x80017, Model = 0x09, Rev = 0x00, 100baseT, FDX => But my Link LED is not glowing at all. Always my Link status shows "Not Active" can anyone throw some light for me..... Regards, Shami...
Stefan Roese sr@denx.de wrote: Hi Shami,
On Thursday 20 December 2007, shami Allam wrote:
I assigned the ethaddr as 192.168.13.246 and after that i run the command "saveenv " and reset the board.
As Wolfgang already mentioned, this is *not* an ethernet address but an IP address.
I got the following Net: ppc_4xx_eth0. once i get the shell prompt i assign the ipaddr as 192.168.13.241 and after that i run the command "saveenv" and reset the board. Now i tried to ping my Host PC which has the IP address as 192.168.13.240, i am getting the following error.....I am not able to ping the host IP. Can you please show some way to come of this issue..... => ping 192.168.13.240 Trying ppc_4xx_eth0 PHY speed read failed, assuming 10bT PHY duplex read failed, assuming half duplex ENET Speed is 10 Mbps - HALF duplex connection
Did you configure the PHY address correctly? What does "mii info" show? how did you configure the PHY address in your board config file?
Best regards, Stefan
===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: office@denx.de =====================================================================
--------------------------------- Now you can chat without downloading messenger. Click here to know how.