Re: [U-Boot] [PATCH 1/2] powerpc/85xx: Add Support for Freescale P1010 Processor

Dear Kumar Gala,

In message 1295023271-11897-1-git-send-email-galak@kernel.crashing.org you wrote:

From: Poonam Aggrwal poonam.aggrwal@freescale.com

Key Features include of the P1010:

• e500v2 core frequency operation of 500 to 800 MHz
• Power consumption less than 5.0 W at 800 MHz core speed
• Dual SATA 3 Gbps controllers with integrated PHY
• Dual PCI Express controllers
• Three 10/100/1000 Mbps enhanced triple-speed Ethernet controllers (eTSECs)
  • TCP/IP acceleration and classification capabilities
  • IEEE 1588 support
  • Lossless flow control
  • RGMII, SGMII
• DDR3 with support for a 32-bit data interface (40 bits including ECC), up to 800 MHz data rate 32/16-bit DDR3 memory controller
• Dedicated security engine featuring trusted boot
• TDM interface
• Dual controller area networks (FlexCAN) controller
• SD/MMC card controller supporting booting from Flash cards
• USB 2.0 host and device controller with an on-chip, high-speed PHY
• Integrated Flash controller (IFC)
• Power Management Controller (PMC)
• Four-channel, general-purpose DMA controller
• I2C controller
• Serial peripheral interface (SPI) controller with master and slave support
• System timers including a periodic interrupt timer, real-time clock, software watchdog timer, and four general-purpose timers
• Dual DUARTs

Signed-off-by: Poonam Aggrwal poonam.aggrwal@freescale.com Signed-off-by: Dipen Dudhat dipen.dudhat@freescale.com Signed-off-by: Kumar Gala galak@kernel.crashing.org

...

--- a/arch/powerpc/include/asm/config.h +++ b/arch/powerpc/include/asm/config.h @@ -69,14 +69,16 @@

/* Enable TSEC2.0 for the platforms that have it if we are using TSEC */ #if defined(CONFIG_TSEC_ENET) && \

• (defined(CONFIG_P1020) || defined(CONFIG_P1011))

• (defined(CONFIG_P1010) || \

• defined(CONFIG_P1020) || defined(CONFIG_P1011))
  

Please keep list sorted.

Best regards,

Wolfgang Denk