Add a GPIO driver which uses the pinctrl driver to access the pad information. This driver relies on the GPIO nodes being subnodes to the pinctrl device.
Signed-off-by: Simon Glass sjg@chromium.org ---
Changes in v4: None Changes in v3: None Changes in v2: None
.../gpio/intel,apl-gpio.txt | 55 ++++++ drivers/gpio/Kconfig | 9 + drivers/gpio/Makefile | 1 + drivers/gpio/intel_gpio.c | 161 ++++++++++++++++++ 4 files changed, 226 insertions(+) create mode 100644 doc/device-tree-bindings/gpio/intel,apl-gpio.txt create mode 100644 drivers/gpio/intel_gpio.c
diff --git a/doc/device-tree-bindings/gpio/intel,apl-gpio.txt b/doc/device-tree-bindings/gpio/intel,apl-gpio.txt new file mode 100644 index 0000000000..e34e7c3501 --- /dev/null +++ b/doc/device-tree-bindings/gpio/intel,apl-gpio.txt @@ -0,0 +1,55 @@ +* Intel Apollo Lake GPIO controller + +The Apollo Lake (APL) GPIO controller is used to control GPIO functions of +the pins. + +Required properties: +- compatible: "intel,apl-gpio" +- #gpio-cells: Should be 2. The syntax of the gpio specifier used by client + nodes should be the following with values derived from the SoC user manual. + <[phandle of the gpio controller node] + [pin number within the gpio controller] + [flags]> + + Values for gpio specifier: + - Pin number: is a GPIO pin number between 0 and 244 + - Flags: GPIO_ACTIVE_HIGH or GPIO_ACTIVE_LOW + +- gpio-controller: Specifies that the node is a gpio controller. + +Example: + +... +{ + p2sb: p2sb@d,0 { + reg = <0x02006810 0 0 0 0>; + compatible = "intel,apl-p2sb"; + early-regs = <IOMAP_P2SB_BAR 0x100000>; + + n { + compatible = "intel,apl-pinctrl"; + intel,p2sb-port-id = <PID_GPIO_N>; + gpio_n: gpio-n { + compatible = "intel,apl-gpio"; + gpio-controller; + #gpio-cells = <2>; + }; + }; + }; + + i2c_2: i2c2@16,2 { + compatible = "intel,apl-i2c", "snps,designware-i2c-pci"; + reg = <0x0200b210 0 0 0 0>; + #address-cells = <1>; + #size-cells = <0>; + clock-frequency = <400000>; + tpm@50 { + reg = <0x50>; + compatible = "google,cr50"; + u-boot,i2c-offset-len = <0>; + ready-gpio = <&gpio_n GPIO_28 GPIO_ACTIVE_LOW>; + }; + }; + +}; +... diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig index 447cf04578..1de6f5225e 100644 --- a/drivers/gpio/Kconfig +++ b/drivers/gpio/Kconfig @@ -104,6 +104,15 @@ config INTEL_BROADWELL_GPIO driver from the common Intel ICH6 driver. It supports a total of 95 GPIOs which can be configured from the device tree.
+config INTEL_GPIO + bool "Intel generic GPIO driver" + depends on DM_GPIO + help + Say yes here to select Intel generic GPIO driver. This controller + supports recent chips (e.g. Apollo Lake). It permits basic GPIO + control including setting pins to input/output. It makes use of its + parent pinctrl driver to actually effect changes. + config INTEL_ICH6_GPIO bool "Intel ICH6 compatible legacy GPIO driver" depends on DM_GPIO diff --git a/drivers/gpio/Makefile b/drivers/gpio/Makefile index 3612e66786..449046b64c 100644 --- a/drivers/gpio/Makefile +++ b/drivers/gpio/Makefile @@ -17,6 +17,7 @@ endif obj-$(CONFIG_AT91_GPIO) += at91_gpio.o obj-$(CONFIG_ATMEL_PIO4) += atmel_pio4.o obj-$(CONFIG_BCM6345_GPIO) += bcm6345_gpio.o +obj-$(CONFIG_INTEL_GPIO) += intel_gpio.o obj-$(CONFIG_INTEL_ICH6_GPIO) += intel_ich6_gpio.o obj-$(CONFIG_INTEL_BROADWELL_GPIO) += intel_broadwell_gpio.o obj-$(CONFIG_KIRKWOOD_GPIO) += kw_gpio.o diff --git a/drivers/gpio/intel_gpio.c b/drivers/gpio/intel_gpio.c new file mode 100644 index 0000000000..eeff95de7b --- /dev/null +++ b/drivers/gpio/intel_gpio.c @@ -0,0 +1,161 @@ +// SPDX-License-Identifier: GPL-2.0+ +/* + * Copyright 2019 Google LLC + */ + +#include <common.h> +#include <dm.h> +#include <errno.h> +#include <fdtdec.h> +#include <p2sb.h> +#include <pch.h> +#include <pci.h> +#include <syscon.h> +#include <asm/cpu.h> +#include <asm/gpio.h> +#include <asm/intel_pinctrl.h> +#include <asm/intel_pinctrl_defs.h> +#include <asm/io.h> +#include <asm/pci.h> +#include <asm/arch/gpio.h> +#include <dt-bindings/gpio/x86-gpio.h> + +static int intel_gpio_direction_input(struct udevice *dev, uint offset) +{ + struct udevice *pinctrl = dev_get_parent(dev); + uint config_offset = intel_pinctrl_get_config_reg_addr(pinctrl, offset); + + pcr_clrsetbits32(pinctrl, config_offset, + PAD_CFG0_MODE_MASK | PAD_CFG0_TX_STATE | + PAD_CFG0_RX_DISABLE, + PAD_CFG0_MODE_GPIO | PAD_CFG0_TX_DISABLE); + + return 0; +} + +static int intel_gpio_direction_output(struct udevice *dev, uint offset, + int value) +{ + struct udevice *pinctrl = dev_get_parent(dev); + uint config_offset = intel_pinctrl_get_config_reg_addr(pinctrl, offset); + + pcr_clrsetbits32(dev, config_offset, + PAD_CFG0_MODE_MASK | PAD_CFG0_RX_STATE | + PAD_CFG0_TX_DISABLE, + PAD_CFG0_MODE_GPIO | PAD_CFG0_RX_DISABLE | + (value ? PAD_CFG0_TX_STATE : 0)); + + return 0; +} + +static int intel_gpio_get_value(struct udevice *dev, uint offset) +{ + struct udevice *pinctrl = dev_get_parent(dev); + uint mode, rx_tx; + u32 reg; + + reg = intel_pinctrl_get_config_reg(pinctrl, offset); + mode = (reg & PAD_CFG0_MODE_MASK) >> PAD_CFG0_MODE_SHIFT; + if (!mode) { + rx_tx = reg & (PAD_CFG0_TX_DISABLE | PAD_CFG0_RX_DISABLE); + if (rx_tx == PAD_CFG0_TX_DISABLE) + return mode & PAD_CFG0_RX_STATE_BIT ? 1 : 0; + else if (rx_tx == PAD_CFG0_RX_DISABLE) + return mode & PAD_CFG0_TX_STATE_BIT ? 1 : 0; + } + + return 0; +} + +static int intel_gpio_set_value(struct udevice *dev, unsigned offset, int value) +{ + struct udevice *pinctrl = dev_get_parent(dev); + uint config_offset = intel_pinctrl_get_config_reg_addr(pinctrl, offset); + + pcr_clrsetbits32(dev, config_offset, PAD_CFG0_TX_STATE, + value ? PAD_CFG0_TX_STATE : 0); + + return 0; +} + +static int intel_gpio_get_function(struct udevice *dev, uint offset) +{ + struct udevice *pinctrl = dev_get_parent(dev); + uint mode, rx_tx; + u32 reg; + + reg = intel_pinctrl_get_config_reg(pinctrl, offset); + mode = (reg & PAD_CFG0_MODE_MASK) >> PAD_CFG0_MODE_SHIFT; + if (!mode) { + rx_tx = reg & (PAD_CFG0_TX_DISABLE | PAD_CFG0_RX_DISABLE); + if (rx_tx == PAD_CFG0_TX_DISABLE) + return GPIOF_INPUT; + else if (rx_tx == PAD_CFG0_RX_DISABLE) + return GPIOF_OUTPUT; + } + + return GPIOF_FUNC; +} + +static int intel_gpio_xlate(struct udevice *orig_dev, struct gpio_desc *desc, + struct ofnode_phandle_args *args) +{ + struct udevice *pinctrl, *dev; + int gpio, ret; + + /* + * GPIO numbers are global in the device tree so it doesn't matter + * which hone is used + */ + gpio = args->args[0]; + ret = intel_pinctrl_get_pad(gpio, &pinctrl, &desc->offset); + if (ret) + return log_msg_ret("bad", ret); + device_find_first_child(pinctrl, &dev); + if (!dev) + return log_msg_ret("no child", -ENOENT); + desc->flags = args->args[1] & GPIO_ACTIVE_LOW ? GPIOD_ACTIVE_LOW : 0; + desc->dev = dev; + + return 0; +} + +static int intel_gpio_probe(struct udevice *dev) +{ + return 0; +} + +static int intel_gpio_ofdata_to_platdata(struct udevice *dev) +{ + struct gpio_dev_priv *upriv = dev_get_uclass_priv(dev); + struct intel_pinctrl_priv *pinctrl_priv = dev_get_priv(dev->parent); + const struct pad_community *comm = pinctrl_priv->comm; + + upriv->gpio_count = comm->last_pad - comm->first_pad + 1; + upriv->bank_name = dev->name; + + return 0; +} + +static const struct dm_gpio_ops gpio_intel_ops = { + .direction_input = intel_gpio_direction_input, + .direction_output = intel_gpio_direction_output, + .get_value = intel_gpio_get_value, + .set_value = intel_gpio_set_value, + .get_function = intel_gpio_get_function, + .xlate = intel_gpio_xlate, +}; + +static const struct udevice_id intel_intel_gpio_ids[] = { + { .compatible = "intel,apl-gpio" }, + { } +}; + +U_BOOT_DRIVER(gpio_intel) = { + .name = "gpio_intel", + .id = UCLASS_GPIO, + .of_match = intel_intel_gpio_ids, + .ops = &gpio_intel_ops, + .ofdata_to_platdata = intel_gpio_ofdata_to_platdata, + .probe = intel_gpio_probe, +};