On Thu, Jan 10, 2013 at 6:26 PM, Tom Rini trini@ti.com wrote:
-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1
On 01/10/2013 11:16 AM, Javier Martinez Canillas wrote:
On Thu, Jan 10, 2013 at 4:35 PM, Tom Rini trini@ti.com wrote:
-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1
On 01/10/2013 04:43 AM, Javier Martinez Canillas wrote:
On Thu, Dec 27, 2012 at 3:25 PM, Igor Grinberg grinberg@compulab.co.il wrote:
On 12/27/12 15:36, Javier Martinez Canillas wrote:
This patch adds an GPIO LED boot status for IGEP boards.
The GPIO LED used is the red LED0 while the Linux kernel uses the green LED0 as the boot status.
By using different GPIO LEDs, the user can know in which step of the boot process the board currently is.
Signed-off-by: Javier Martinez Canillas javier.martinez@collabora.co.uk
Acked-by: Igor Grinberg grinberg@compulab.co.il
Hello Tom,
Any news of merging this patch?
Things look good, sorry. I'm going to try and get to starting a next branch but I might not get a chance before the next release.
- -- Tom
Great, waiting for the next release is not an issue.
There are also two more patches for IGEP boards that were acked but not picked for this release:
[U-Boot,v2,1/2] OMAP3: use a single board file for IGEP devices [1] [U-Boot,1/1] OMAP3: igep00x0: add CONFIG_SPL_BOARD_INIT for CONFIG_SPL_NAND_SUPPORT [2]
For the second path, did SPL+NAND for the IGEP devices get added already?
Tom
Yes, it was added on mainline commit d271a6114 "OMAP3: igep00x0: add SPL support for IGEP-based boards"
Before posting that patch I only tested SPL booting from the uSD/MMC and later when trying SPL boot from NAND I realized that CONFIG_SPL_BOARD_INIT was missing to initialize the GPMC.
Sorry, my bad. I should have tested both MMC and NAND booting before posting the SPL support patch.
Thanks a lot and best regards, Javier