In case the PHY is fully described in DT, use PHY MDIO address from DT directly instead of always using auto-detection. This also fixes the behavior of 'mdio list' in such DT setup, which now prints the PHY connected to the MAC correctly.
Signed-off-by: Marek Vasut marek.vasut+renesas@mailbox.org --- Cc: Joe Hershberger joe.hershberger@ni.com Cc: Paul Barker paul.barker.ct@bp.renesas.com Cc: Ramon Fried rfried.dev@gmail.com --- drivers/net/ravb.c | 8 +++++++- 1 file changed, 7 insertions(+), 1 deletion(-)
diff --git a/drivers/net/ravb.c b/drivers/net/ravb.c index 0bcd6cfd3f3..e1f61f514c8 100644 --- a/drivers/net/ravb.c +++ b/drivers/net/ravb.c @@ -12,6 +12,7 @@ #include <clk.h> #include <cpu_func.h> #include <dm.h> +#include <eth_phy.h> #include <errno.h> #include <log.h> #include <miiphy.h> @@ -309,9 +310,14 @@ static int ravb_phy_config(struct udevice *dev) struct ravb_priv *eth = dev_get_priv(dev); struct eth_pdata *pdata = dev_get_plat(dev); struct phy_device *phydev; + int phy_addr; int reg;
- phydev = phy_connect(eth->bus, -1, dev, pdata->phy_interface); + phy_addr = eth_phy_get_addr(dev); + if (phy_addr < 0) + phy_addr = -1; + + phydev = phy_connect(eth->bus, phy_addr, dev, pdata->phy_interface); if (!phydev) return -ENODEV;