On Thu 2014-11-13 11:23:41, dinguyen@opensource.altera.com wrote:
From: Dinh Nguyen dinguyen@opensource.altera.com
Set the PHY skew settings for the ethernet phy on the SOCFPGA Cyclone5 hardware.
Is it to need similar settings for all ksz9021 phys? Should this go to drivers/ as I suggested with a patch?
Thanks, Pavel
Signed-off-by: Dinh Nguyen dinguyen@opensource.altera.com Cc: Vince Bridgers vbridger@opensource.altera.com Cc: Pavel Machek pavel@denx.de Cc: Marek Vasut marex@denx.de Cc: Tom Rini trini@ti.com Cc: Albert Aribaud albert.u.boot@aribaud.net Cc: Wolfgang Denk wd@denx.de
v2: Added comments on why it is necessary for setting the skew values.
board/altera/socfpga/socfpga_cyclone5.c | 16 ++++++++++++++++ 1 file changed, 16 insertions(+)
diff --git a/board/altera/socfpga/socfpga_cyclone5.c b/board/altera/socfpga/socfpga_cyclone5.c index 0f81d89..543a143 100644 --- a/board/altera/socfpga/socfpga_cyclone5.c +++ b/board/altera/socfpga/socfpga_cyclone5.c @@ -8,7 +8,9 @@ #include <asm/arch/reset_manager.h> #include <asm/io.h>
+#include <micrel.h> #include <netdev.h> +#include <phy.h>
DECLARE_GLOBAL_DATA_PTR;
@@ -39,3 +41,17 @@ int board_init(void)
return 0; }
+int board_phy_config(struct phy_device *phydev) +{
- /*
* These skew settings for the KSZ9021 ethernet phy is required for ethernet* to work reliably on most flavors of cyclone5 boards.*/- ksz9021_phy_extended_write(phydev, MII_KSZ9021_EXT_RGMII_RX_DATA_SKEW,
0x0);- ksz9021_phy_extended_write(phydev, MII_KSZ9021_EXT_RGMII_TX_DATA_SKEW,
0x0);- ksz9021_phy_extended_write(phydev, MII_KSZ9021_EXT_RGMII_CLOCK_SKEW,
0xf0f0);+}