Signed-off-by: Samuel Egli samuel.egli@siemens.com Reviewed-by: Roger Meier r.meier@siemens.com Cc: Heiko Schocher hs@denx.de Cc: Wolfgang Denk wd@denx.de --- boards.cfg | 1 + include/configs/draco.h | 92 +++++++++++++++++++++++++++++++++++++++++++++++ 2 files changed, 93 insertions(+) create mode 100644 include/configs/draco.h
diff --git a/boards.cfg b/boards.cfg index 76c8764..4cc0235 100644 --- a/boards.cfg +++ b/boards.cfg @@ -260,6 +260,7 @@ Active arm armv7 am33xx compulab cm_t335 Active arm armv7 am33xx isee igep0033 am335x_igep0033 - Enric Balletbo i Serra eballetbo@iseebcn.com Active arm armv7 am33xx phytec pcm051 pcm051_rev1 pcm051:REV1 Lars Poeschel poeschel@lemonage.de Active arm armv7 am33xx phytec pcm051 pcm051_rev3 pcm051:REV3 Lars Poeschel poeschel@lemonage.de +Active arm armv7 am33xx siemens draco draco - Roger Meier r.meier@siemens.com Active arm armv7 am33xx siemens draco dxr2 - Roger Meier r.meier@siemens.com Active arm armv7 am33xx siemens pxm2 pxm2 - Roger Meier r.meier@siemens.com Active arm armv7 am33xx siemens rut rut - Roger Meier r.meier@siemens.com diff --git a/include/configs/draco.h b/include/configs/draco.h new file mode 100644 index 0000000..a2438d8 --- /dev/null +++ b/include/configs/draco.h @@ -0,0 +1,92 @@ +/* + * (C) Copyright 2013 Siemens Schweiz AG + * (C) Heiko Schocher, DENX Software Engineering, hs@denx.de. + * + * Based on: + * U-Boot file:/include/configs/am335x_evm.h + * + * Copyright (C) 2011 Texas Instruments Incorporated - http://www.ti.com/ + * + * SPDX-License-Identifier: GPL-2.0+ + */ + +#ifndef __CONFIG_DRACO_H +#define __CONFIG_DRACO_H + +#define CONFIG_SIEMENS_DRACO +#define MACH_TYPE_DRACO 4314 +#define CONFIG_SIEMENS_MACH_TYPE MACH_TYPE_DRACO + +#include "siemens-am33x-common.h" + +#define CONFIG_SYS_MPUCLK 275 +#define DDR_PLL_FREQ 303 +#undef CONFIG_SPL_AM33XX_ENABLE_RTC32K_OSC + +#define BOARD_DFU_BUTTON_GPIO 27 +#define BOARD_DFU_BUTTON_LED 64 /* red LED */ +#define BOARD_STATUS_LED 103 /* green LED */ +#define GPIO_LAN9303_NRST 88 /* GPIO2_24 = gpio88 */ + +#undef CONFIG_DOS_PARTITION +#undef CONFIG_CMD_FAT + + + /* Physical Memory Map */ +#define CONFIG_MAX_RAM_BANK_SIZE (1024 << 20) /* 1GB */ + +/* I2C Configuration */ +#define CONFIG_SYS_I2C_SPEED 100000 + +#define CONFIG_SYS_I2C_EEPROM_ADDR 0x50 +#define EEPROM_ADDR_DDR3 0x90 +#define EEPROM_ADDR_CHIP 0x120 + +#define CONFIG_SYS_U_BOOT_MAX_SIZE_SECTORS 0x300 + +#undef CONFIG_SPL_NET_SUPPORT +#undef CONFIG_SPL_NET_VCI_STRING +#undef CONFIG_SPL_ETH_SUPPORT + +#undef CONFIG_MII +#undef CONFIG_PHY_GIGE +#define CONFIG_PHY_SMSC + +#define CONFIG_FACTORYSET + +/* Watchdog */ +#define CONFIG_OMAP_WATCHDOG + +#ifndef CONFIG_SPL_BUILD + +/* Default env settings */ +#define CONFIG_EXTRA_ENV_SETTINGS \ + "nand_img_size=0x400000\0" \ + "optargs=\0" \ + CONFIG_COMMON_ENV_SETTINGS + +#ifndef CONFIG_RESTORE_FLASH +/* set to negative value for no autoboot */ +#define CONFIG_BOOTDELAY 3 + +#define CONFIG_BOOTCOMMAND \ +"if dfubutton; then " \ + "run dfu_start; " \ + "reset; " \ +"fi;" \ +"run nand_boot;" \ +"reset;" + + +#else +#define CONFIG_BOOTDELAY 0 + +#define CONFIG_BOOTCOMMAND \ + "setenv autoload no; " \ + "dhcp; " \ + "if tftp 80000000 debrick.scr; then " \ + "source 80000000; " \ + "fi" +#endif +#endif /* CONFIG_SPL_BUILD */ +#endif /* ! __CONFIG_DRACO_H */