Re: [U-Boot] How !, Adding a New Device to U-Boot.

Dear renjith kumar,

In message a8474bd70903181921p383be5aatcf36a1727f8f3085@mail.gmail.com you wrote:

I was wondering , is there any Discussion or document that describe the way how I can Add a new device to u-Boot.

There is the README, and there is the U-Boot home page, especially http://www.denx.de/wiki/U-Boot/Patches

For example , I have two sequoa based, Custom design.

1. . I have an FPGA Device at the EBC port of EPx in the second design.

2. . In a second case, I have an FPGA Device as the PCI card for ppc440EPx.

(May be ok with Normal PCI Detection, but How to drive it ? Any standard approach).

If this is the only difference, then eventually a single new board configuration may be sufficient.

Best regards,

Wolfgang Denk