On Wed, Jun 12, 2019 at 2:02 PM Shyam Saini shyam.saini@amarulasolutions.com wrote:
Add Kconfig entry for CMD_NANDBCB, and default y on i.MX6 platform with NAND_MXS defined.
Reviewed-by: Stefano Babic sbabic@denx.de Signed-off-by: Jagan Teki jagan@amarulasolutions.com Signed-off-by: Shyam Saini shyam.saini@amarulasolutions.com
Hi,
This patch series is based on feedback gathered from this [1] discussion and [2] patch submitted by Stefan.
[1] https://patchwork.ozlabs.org/patch/870467/ [2] https://patchwork.ozlabs.org/patch/897222/
Changes for v5:
- New patch
Changes for v4:
- No change
Changes for v3:
- Fixed Typo 'seprate'
Changes for v2:
- New patch
arch/arm/mach-imx/Kconfig | 11 +++++++++++ 1 file changed, 11 insertions(+)
diff --git a/arch/arm/mach-imx/Kconfig b/arch/arm/mach-imx/Kconfig index ec09ef240f..5dd286f9a7 100644 --- a/arch/arm/mach-imx/Kconfig +++ b/arch/arm/mach-imx/Kconfig @@ -71,6 +71,17 @@ config CMD_HDMIDETECT This enables the 'hdmidet' command which detects if an HDMI monitor is connected.
+config CMD_NANDBCB
bool "i.MX6 NAND Boot Control Block(BCB) command"depends on NAND && CMD_MTDPARTSdefault y if ARCH_MX6 && NAND_MXShelpUnlike normal 'nand write/erase' commands, this command updateBoot Control Block(BCB) for i.MX6 platform NAND IP's.This is similar to kobs-ng, which is used in Linux as separaterootfs package.
This patch structuring is not in proper order.
01: Add support for nandbcb (would have all required code, kconfig, makefile changes) 02: Enable it on board config. 03: Readme, about the steps.