Hi,
On 08-07-16 12:40, Tobias Doerffel wrote:
With a recent bunch of SD3.0 cards in our A20-based board we experienced data transfer rates of about 250 KiB/s instead of 10 MiB/s with previous cards from the same vendor (both 4 GB/class 10). By increasing status register polling rate from 1 kHz to 1 MHz we were able to reach the original transfer rates again. With the old cards we now even reach about 16 MiB/s.
Signed-off-by: Tobias Doerffel tobias.doerffel@ed-chemnitz.de
Thanks, this tremendously speeds up boot on some of my boards, good stuff!
I've merge this locally and it should show up in u-boot-sunxi/next later today.
Regards,
Hans
drivers/mmc/sunxi_mmc.c | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-)
diff --git a/drivers/mmc/sunxi_mmc.c b/drivers/mmc/sunxi_mmc.c index ce2dc4a..36da3b3 100644 --- a/drivers/mmc/sunxi_mmc.c +++ b/drivers/mmc/sunxi_mmc.c @@ -269,18 +269,18 @@ static int mmc_trans_data_by_cpu(struct mmc *mmc, struct mmc_data *data) unsigned i; unsigned *buff = (unsigned int *)(reading ? data->dest : data->src); unsigned byte_cnt = data->blocksize * data->blocks;
- unsigned timeout_msecs = byte_cnt >> 8;
- if (timeout_msecs < 2000)
timeout_msecs = 2000;
unsigned timeout_usecs = (byte_cnt >> 8) * 1000;
if (timeout_usecs < 2000000)
timeout_usecs = 2000000;/* Always read / write data through the CPU */ setbits_le32(&mmchost->reg->gctrl, SUNXI_MMC_GCTRL_ACCESS_BY_AHB);
for (i = 0; i < (byte_cnt >> 2); i++) { while (readl(&mmchost->reg->status) & status_bit) {
if (!timeout_msecs--)
if (!timeout_usecs--) return -1;
udelay(1000);
udelay(1);}
if (reading)