Hi Nikita,
On 29/10/2014 18:28, Nikita Kiryanov wrote:
The bmode command forces the SoC to use a specific boot device by writing its boot mode into SRC_GPR9, and notifying the SoC of the change using SRC_GPR10[28] bit: if the bit is on, bootROM uses the value in SRC_GPR9 instead of SRC_SMBR1 to determine the boot device.
SPL on the other hand is oblivious to this distinction, so once the bootROM loads SPL from the device configured in SRC_GPR10, SPL will attempt to load U-Boot from the device configured in SRC_SMBR1, which is not updated by the bootROM to the value in SRC_GPR9.
The result is that the selected boot device is not used across all the boot stages.
Update spl_boot_device() to look at gpr9 when necessary.
Signed-off-by: Nikita Kiryanov nikita@compulab.co.il Cc: Stefano Babic sbabic@denx.de Cc: Troy Kisky troy.kisky@boundarydevices.com Cc: Tim Harvey tharvey@gateworks.com Cc: Eric Nelson eric.nelson@boundarydevices.com Cc: Fabio Estevam fabio.estevam@freescale.com Cc: Heiko Schocher hs@denx.de
Applied to u-boot-imx, thanks !
Best regards, Stefano Babic