17 May
2011
17 May
'11
2:44 p.m.
On 05/17/2011 07:06 AM, Jason Liu wrote:
Hi, Fabio,
2011/5/17 Fabio Estevam fabio.estevam@freescale.com:
Make the weim register set complete for MX51/MX53.
While at it also add the weim chip select 1 address definition.
From the code, you just add the cs for mx53 not for mx51, so, Had better specify you add the cs1 address definition for mx53, otherwise, it will make confusion.
Sure ? The structure is not protected by any CONFIG_MX5x switch, and at least one mx51 board uses it. The registers have the same layout for both processor. Why do you think is only for MX53 ?
Regards, Stefano Babic
--
=====================================================================
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: office@denx.de
=====================================================================